Parti

Nessuna parte richiesta.

Unscrew and remove the four screws from the left side of the camera (from the screen's view) Unscrew and remove the four screws from the left side of the camera (from the screen's view)
  • Unscrew and remove the four screws from the left side of the camera (from the screen's view)

Aggiungi Commento

Unscrew and remove the three screws from the bottom of the camera
  • Unscrew and remove the three screws from the bottom of the camera

Aggiungi Commento

Unscrew and remove the two screws from the right side of the camera. Unscrew and remove the two screws from the right side of the camera.
  • Unscrew and remove the two screws from the right side of the camera.

Aggiungi Commento

Open the battery flap and remove the batteries. Keep the battery flap open.
  • Open the battery flap and remove the batteries.

  • Keep the battery flap open.

Aggiungi Commento

Use a spudger to gently separate the two halves of the camera's outer casing.
  • Use a spudger to gently separate the two halves of the camera's outer casing.

Aggiungi Commento

Gently pull the half of the case with the screen (the back half) from the rest of the camera.
  • Gently pull the half of the case with the screen (the back half) from the rest of the camera.

  • Be sure not too pull to hard. The screen is still attached to the motherboard. If you pull too hard you will rip it.

Aggiungi Commento

The back half (the half with the screen on it) should now be separate from the rest of the camera, but still attached by the ribbon. The back half (the half with the screen on it) should now be separate from the rest of the camera, but still attached by the ribbon.
  • The back half (the half with the screen on it) should now be separate from the rest of the camera, but still attached by the ribbon.

Aggiungi Commento

Use a spudger to lift the black flap that clamps the ribbon towards you. When the black flap is open it will be straight up. (like in the second picture)
  • Use a spudger to lift the black flap that clamps the ribbon towards you.

  • When the black flap is open it will be straight up. (like in the second picture)

Aggiungi Commento

Now that the black flap is open, gently pull the ribbon out.
  • Now that the black flap is open, gently pull the ribbon out.

  • You should now have the back half of the camera completely separate from the rest of the camera.

Aggiungi Commento

This is what the back half of the camera should look like. This is what the rest of the camera will look like.
  • This is what the back half of the camera should look like.

  • This is what the rest of the camera will look like.

Aggiungi Commento

Unscrew and remove two screws from the logic board.
  • Unscrew and remove two screws from the logic board.

Aggiungi Commento

Pull the front half off of the logic board.
  • Pull the front half off of the logic board.

Aggiungi Commento

This will be the front half of the outer case.
  • This will be the front half of the outer case.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team 3-4, Johann Summer 2010 Membro di Cal Poly, Team 3-4, Johann Summer 2010

CPSU-JOHANN-R10S3G4

4 Membri

4 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 1,228