Salta al contenuto principale

PlayStation 2 Slimline IR Sensor Replacement

Cosa ti serve

  1. PlayStation 2 Slimline IR Sensor Replacement, Outer Shell: passo 1, immagine 1 di 1
    • Disconnect all cables from the console and flip the unit over to reveal its base.

  2. PlayStation 2 Slimline IR Sensor Replacement: passo 2, immagine 1 di 3 PlayStation 2 Slimline IR Sensor Replacement: passo 2, immagine 2 di 3 PlayStation 2 Slimline IR Sensor Replacement: passo 2, immagine 3 di 3
    • Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.

    • Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.

  3. PlayStation 2 Slimline IR Sensor Replacement: passo 3, immagine 1 di 3 PlayStation 2 Slimline IR Sensor Replacement: passo 3, immagine 2 di 3 PlayStation 2 Slimline IR Sensor Replacement: passo 3, immagine 3 di 3
    • Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.

  4. PlayStation 2 Slimline IR Sensor Replacement: passo 4, immagine 1 di 3 PlayStation 2 Slimline IR Sensor Replacement: passo 4, immagine 2 di 3 PlayStation 2 Slimline IR Sensor Replacement: passo 4, immagine 3 di 3
    • Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit.

    • Note: You may use your hands for additional force to separate the two pieces of the outer shell.

  5. PlayStation 2 Slimline IR Sensor Replacement, IR Sensor: passo 5, immagine 1 di 1
    • Locate the IR sensor at the front, right corner of the unit.

  6. PlayStation 2 Slimline IR Sensor Replacement: passo 6, immagine 1 di 1
    • Gently detach the ribbon cable connecting the IR sensor to the motherboard.

    • Caution: Always remove ribbon cables by the plastic handles located on either end. Gripping a ribbon cable anywhere but the provided handles can damage the cable and render the component useless.

  7. PlayStation 2 Slimline IR Sensor Replacement: passo 7, immagine 1 di 1
    • Gently lift and remove the IR Sensor from its designated slot.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 7 persone hanno completato questa guida.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 4

Ultimi 7 Giorni: 12

Ultimi 30 Giorni: 73

Tutti i Tempi: 6,734