Introduzione

This guide will provide you with step by step instructions to replace your Toughbook CF-29's speaker.

Locate the bay door for the battery on the left side of the laptop.
  • Locate the bay door for the battery on the left side of the laptop.

Aggiungi Commento

Slide the latch to the right and then down to unlock it. Pull out the battery.
  • Slide the latch to the right and then down to unlock it.

  • Pull out the battery.

Aggiungi Commento

Begin by turning the laptop upside down with the handle towards you.
  • Begin by turning the laptop upside down with the handle towards you.

  • Use a Phillips size 0 screwdriver to remove the 4 screws holding down the ram cover.

Aggiungi Commento

Remove the panel and set it aside.
  • Remove the panel and set it aside.

  • Use a Phillips size 0 screwdriver to remove these 8 small screws.

Aggiungi Commento

Use a Phillips size 1 screwdriver to remove the remaining 8 screws.
  • Use a Phillips size 1 screwdriver to remove the remaining 8 screws.

Aggiungi Commento

Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive. Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.
  • Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.

Aggiungi Commento

Be careful when lifting the cover as you may damage some connections.
  • Be careful when lifting the cover as you may damage some connections.

  • Slowly lift the cover so that you can disconnect the red and white wires connecting the speaker to the sound card.

Aggiungi Commento

Now the back cover should be off and you can access the inside of the casing.
  • Now the back cover should be off and you can access the inside of the casing.

Aggiungi Commento

Place the back cover infront of you so you can access the inside of it.
  • Place the back cover infront of you so you can access the inside of it.

  • Remove the 3 screws holding in the speaker.

Aggiungi Commento

Pry out the speaker using a flat screw driver or a blue pry tool.  It is held in with an adhesive.
  • Pry out the speaker using a flat screw driver or a blue pry tool. It is held in with an adhesive.

Aggiungi Commento

Your speaker is now removed
  • Your speaker is now removed

  • Put in your replacement by following the reverse steps.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Rohun Heesen

Membro da: 13/04/2010

330 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 27-93, Amido Spring 2010 Membro di Cal Poly, Team 27-93, Amido Spring 2010

CPSU-AMIDO-S10S27G93

4 Membri

12 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 4,977