Introduzione

The purpose of this guide is to show how to properly remove and replace the heat sink.

Locate the bay door for the battery on the left side of the laptop.
  • Locate the bay door for the battery on the left side of the laptop.

Aggiungi Commento

Slide the latch to the right and then down to unlock it. Pull out the battery.
  • Slide the latch to the right and then down to unlock it.

  • Pull out the battery.

Aggiungi Commento

Begin by turning the laptop upside down with the handle towards you.
  • Begin by turning the laptop upside down with the handle towards you.

  • Use a Phillips size 0 screwdriver to remove the 4 screws holding down the ram cover.

Aggiungi Commento

Remove the panel and set it aside.
  • Remove the panel and set it aside.

  • Use a Phillips size 0 screwdriver to remove these 8 small screws.

Aggiungi Commento

Use a Phillips size 1 screwdriver to remove the remaining 8 screws.
  • Use a Phillips size 1 screwdriver to remove the remaining 8 screws.

Aggiungi Commento

Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive. Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.
  • Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.

Aggiungi Commento

Be careful when lifting the cover as you may damage some connections.
  • Be careful when lifting the cover as you may damage some connections.

  • Slowly lift the cover so that you can disconnect the red and white wires connecting the speaker to the sound card.

Aggiungi Commento

Now the back cover should be off and you can access the inside of the casing.
  • Now the back cover should be off and you can access the inside of the casing.

Aggiungi Commento

Locate the heat sink on the underside of the back cover.
  • Locate the heat sink on the underside of the back cover.

    • It is the U shaped metallic piece.

Aggiungi Commento

Remove the four screws with a Phillips size 1 screwdriver.
  • Remove the four screws with a Phillips size 1 screwdriver.

    • One on each of the ends

    • Two on the base of the U shape

Aggiungi Commento

Being careful not to lose the brackets at the ends of the heat sink, lift it up and out.
  • Being careful not to lose the brackets at the ends of the heat sink, lift it up and out.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Clint Kirsop

Membro da: 13/04/2010

67 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 27-93, Amido Spring 2010 Membro di Cal Poly, Team 27-93, Amido Spring 2010

CPSU-AMIDO-S10S27G93

4 Membri

12 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 12

Tutti i Tempi: 5,127