Salta al contenuto principale

Palm TX Back Panel Replacement

Cosa ti serve

  1. Palm TX Back Panel Replacement, Back Panel: passo 1, immagine 1 di 2 Palm TX Back Panel Replacement, Back Panel: passo 1, immagine 2 di 2
    • Orient the device so that the display faces forward.

    • Remove the stylus from the right side.

  2. Palm TX Back Panel Replacement: passo 2, immagine 1 di 1
    • Turn over the device so that the back panel faces forward.

    • Use a T5 Torx screwdriver to remove the four 6.35mm corner screws.

  3. Palm TX Back Panel Replacement: passo 3, immagine 1 di 2 Palm TX Back Panel Replacement: passo 3, immagine 2 di 2
    • Rotate the device so that the display faces forward.

    • Insert a plastic opening tool with the angled tip pointing downward into the crevice on the left side of the device.

    • Pry along the crevice to loosen the back panel.

    • Repeat this process for the right side.

  4. Palm TX Back Panel Replacement: passo 4, immagine 1 di 2 Palm TX Back Panel Replacement: passo 4, immagine 2 di 2
    • Carefully pry the back panel to open the device.

    • Be careful not to break the wire that connects the battery pack to the motherboard.

    • When reassembling, snap the back panel back into place and then insert the top cover.

  5. Palm TX Back Panel Replacement: passo 5, immagine 1 di 2 Palm TX Back Panel Replacement: passo 5, immagine 2 di 2
    • Use a plastic opening tool to peel the battery pack from the back panel.

    • The battery pack is glued to the back panel so removing it may require considerable effort.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Cal Poly, Team 1-15, Amido Winter 2011 Membro di Cal Poly, Team 1-15, Amido Winter 2011

CPSU-AMIDO-W11S1G15

4 Membri

7 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 7

Tutti i Tempi: 1,539