Parti

Nessuna parte richiesta.

Make sure your Palm Pre is turned off before disassembling the phone.
  • Make sure your Palm Pre is turned off before disassembling the phone.

  • Snap off the back panel to reveal the battery.

Aggiungi Commento

Carefully pull up on the tab to remove the current battery.
  • Carefully pull up on the tab to remove the current battery.

Aggiungi Commento

Use the T5 Torx Screwdriver to remove the six screws holding the backing frame in place. Use the T5 Torx Screwdriver to remove the six screws holding the backing frame in place.
  • Use the T5 Torx Screwdriver to remove the six screws holding the backing frame in place.

Aggiungi Commento

Locate the hinge that covers the black and white GPS and DIV antennas. (The hinge will be located in the red box as portrayed in the picture.)
  • Locate the hinge that covers the black and white GPS and DIV antennas. (The hinge will be located in the red box as portrayed in the picture.)

  • Use a spudger to pry open the hinge.

  • Use tweezers to disconnect the antennas from the keypad control board.

Aggiungi Commento

Use a spudger to pry off the (black and yellow) back frame. Disregard the main part of the phone at this point and look only at the inside of the removed back frame. (You will need the main part of the phone for access to the keyboard and motherboard)
  • Use a spudger to pry off the (black and yellow) back frame.

    • Disregard the main part of the phone at this point and look only at the inside of the removed back frame. (You will need the main part of the phone for access to the keyboard and motherboard)

Aggiungi Commento

Find the small circuit board at the top right and desolder the wires that are connected to it.
  • Find the small circuit board at the top right and desolder the wires that are connected to it.

    • This step is only necessary for antenna removal.

Aggiungi Commento

Remove the two ribbon cable connectors using tweezers.
  • Remove the two ribbon cable connectors using tweezers.

Aggiungi Commento

Use a spudger to remove the keypad control board. There is heavy adhesive connecting this part to the keypad sensors.
  • Use a spudger to remove the keypad control board.

    • There is heavy adhesive connecting this part to the keypad sensors.

Aggiungi Commento

Slide the keyboard away from the phone.
  • Slide the keyboard away from the phone.

  • Use tweezers to separate the keyboard from the phone if adhesive is inhibiting removal.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

noha

Membro da: 12/04/2012

139 Reputazione

12 Guide realizzate

Team

Cal Poly, Team 7-31, Maness Spring 2012 Membro di Cal Poly, Team 7-31, Maness Spring 2012

CPSU-MANESS-S12S7G31

3 Membri

16 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,126