Introduzione

This guide shows how to replace a broken retainer clip (the plastic piece that covers the battery and XD card slot).

Parti

Nessuna parte richiesta.

Flip camera so you are looking at the bottom.
  • Flip camera so you are looking at the bottom.

  • Unscrew all 5 base plate screws.

Aggiungi Commento

Lift open retainer clip by sliding the clip to the left and letting the clip pop up.
  • Lift open retainer clip by sliding the clip to the left and letting the clip pop up.

Aggiungi Commento

Unscrew the single screw located next to the battery slot.
  • Unscrew the single screw located next to the battery slot.

Aggiungi Commento

Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.
  • Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.

  • Lift the rubber plate exposing the ports beneath.

Aggiungi Commento

Unscrew the 2 screws next to the USB and AC ports.
  • Unscrew the 2 screws next to the USB and AC ports.

Aggiungi Commento

Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.
  • Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.

Aggiungi Commento

Pull off the faceplate to reveal the inside of the camera.
  • Pull off the faceplate to reveal the inside of the camera.

  • Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

Aggiungi Commento

Orient the camera as shown, with the bottom facing up.
  • Orient the camera as shown, with the bottom facing up.

  • Open the retainer clip, by using your finger to push down and slide to the left.

  • The clip should pop open.

Aggiungi Commento

Hold the retainer clip down (without re-latching it).
  • Hold the retainer clip down (without re-latching it).

  • Use a flathead screwdriver to start to pry out the pin holding the retainer clip's spring to the camera.

Aggiungi Commento

Use tweezers to continue to remove the pin.
  • Use tweezers to continue to remove the pin.

Aggiungi Commento

When it feels loose, pull the pin all the way out with your fingers.
  • When it feels loose, pull the pin all the way out with your fingers.

Aggiungi Commento

Once the pin comes out, the retainer clip, spring, and pin will no longer be attached to the rest of the camera.
  • Once the pin comes out, the retainer clip, spring, and pin will no longer be attached to the rest of the camera.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Katie

Membro da: 15/04/2010

25 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 28-23, Regan Spring 2010 Membro di Cal Poly, Team 28-23, Regan Spring 2010

CPSU-REGAN-S10S28G23

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 2,055