Parti

Nessuna parte richiesta.

Flip over the turntable and remove the 9 screws on the outer edges. Flip over the turntable and remove the 9 screws on the outer edges.
  • Flip over the turntable and remove the 9 screws on the outer edges.

Aggiungi Commento

Remove the back cover by pulling it apart.
  • Remove the back cover by pulling it apart.

Aggiungi Commento

Remove the clip located on the backside of the audio jack housing by gently pulling it out. There will be some resistance but continue to pull gently. The clip is located right underneath the audio jacks.
  • Remove the clip located on the backside of the audio jack housing by gently pulling it out.

  • There will be some resistance but continue to pull gently.

  • The clip is located right underneath the audio jacks.

Aggiungi Commento

Remove the screw that connects the black wire of the tone arm to the base of the audio jack housing. Remove the screw that connects the black wire of the tone arm to the base of the audio jack housing. Remove the screw that connects the black wire of the tone arm to the base of the audio jack housing.
  • Remove the screw that connects the black wire of the tone arm to the base of the audio jack housing.

Aggiungi Commento

Gently pull the wire that you just unscrewed to release it from the clip. Gently pull the wire that you just unscrewed to release it from the clip.
  • Gently pull the wire that you just unscrewed to release it from the clip.

Aggiungi Commento

Remove the two screws connecting the circuit board to the tone arm. Remove the two screws connecting the circuit board to the tone arm. Remove the two screws connecting the circuit board to the tone arm.
  • Remove the two screws connecting the circuit board to the tone arm.

Aggiungi Commento

Remove the two remaining screws connecting the tone arm to the device. Remove the two remaining screws connecting the tone arm to the device.
  • Remove the two remaining screws connecting the tone arm to the device.

Aggiungi Commento

Flip the turntable back over to the top side.
  • Flip the turntable back over to the top side.

  • Remove the counter weight located at the back of the tone arm.

Aggiungi Commento

Push out the pin keeping the tone arm in place using a Phillips #00 screwdriver. Once you have pushed the pin out with the screwdriver, pull the rest of it out using your hand. Once you have pushed the pin out with the screwdriver, pull the rest of it out using your hand.
  • Push out the pin keeping the tone arm in place using a Phillips #00 screwdriver.

  • Once you have pushed the pin out with the screwdriver, pull the rest of it out using your hand.

Aggiungi Commento

Pick up the tone arm and point the back end of it towards its base. Push the back end of the tone arm into the hole. Flip the turntable over and pull the tone arm all the way through the hole.
  • Pick up the tone arm and point the back end of it towards its base.

  • Push the back end of the tone arm into the hole.

  • Flip the turntable over and pull the tone arm all the way through the hole.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Nikolai

Membro da: 12/10/2011

161 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 17-14, Regan Fall 2011 Membro di Cal Poly, Team 17-14, Regan Fall 2011

CPSU-REGAN-F11S17G14

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 11

Ultimi 30 Giorni: 49

Tutti i Tempi: 4,324