Parti

Nessuna parte richiesta.

Orient the phone as shown.
  • Orient the phone as shown.

  • Press the button with the plastic opening tool and slide the back case downward relative to the phone.

Aggiungi Commento

Remove the battery cover by lifting it away from the phone.
  • Remove the battery cover by lifting it away from the phone.

Aggiungi Commento

Insert the plastic opening tool into the marked space.
  • Insert the plastic opening tool into the marked space.

  • Lift up the side of the battery closest to the bottom edge of the phone using the plastic opening tool.

Aggiungi Commento

Remove the battery from the phone.
  • Remove the battery from the phone.

Aggiungi Commento

Insert the plastic opening tool in the marked areas in between the front and back covers. Pry each corner with the plastic opening tool until the front case completely detaches. Pry each corner with the plastic opening tool until the front case completely detaches.
  • Insert the plastic opening tool in the marked areas in between the front and back covers.

  • Pry each corner with the plastic opening tool until the front case completely detaches.

Aggiungi Commento

Orient the phone so that the keypad is facing you. Remove the keypad by lifting it away from the phone. Remove the keypad by lifting it away from the phone.
  • Orient the phone so that the keypad is facing you.

  • Remove the keypad by lifting it away from the phone.

Aggiungi Commento

Using T6 Torx screwdriver remove the six 15 mm torx screws. Using T6 Torx screwdriver remove the six 15 mm torx screws.
  • Using T6 Torx screwdriver remove the six 15 mm torx screws.

Aggiungi Commento

Separate the front panel from the back by lifting the bottom of the front panel at a 45 degree angle. Remove the front panel by lifting the panel away from the phone at a 45 degree angle. Remove the front panel by lifting the panel away from the phone at a 45 degree angle.
  • Separate the front panel from the back by lifting the bottom of the front panel at a 45 degree angle.

  • Remove the front panel by lifting the panel away from the phone at a 45 degree angle.

Aggiungi Commento

Locate the rear circuit board by flipping over the front panel. Locate the rear camera and by using the plastic opening tool, gently lift the camera out of the slot. Caution: Be careful when prying camera out of the slot for the connections are fragile.
  • Locate the rear circuit board by flipping over the front panel.

  • Locate the rear camera and by using the plastic opening tool, gently lift the camera out of the slot.

  • Caution: Be careful when prying camera out of the slot for the connections are fragile.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Justin

Membro da: 12/10/2011

924 Reputazione

10 Guide realizzate

Team

Cal Poly, Team 6-2, Regan Fall 2011 Membro di Cal Poly, Team 6-2, Regan Fall 2011

CPSU-REGAN-F11S6G2

4 Membri

10 Guide realizzate

mon nokia n70 est mal camera alors quest -ce qu*on va faire

sidiahmed ahmed - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 18

Tutti i Tempi: 8,203