Introduzione

Remove the back panel to access the internal components of your Nokia Lumia 920.

Make sure the phone is off. Use the T5 screwdriver to remove the two 8.6mm long screws, located at the bottom of the phone. (Head size is 2.5mm) Use the T5 screwdriver to remove the two 8.6mm long screws, located at the bottom of the phone. (Head size is 2.5mm)
  • Make sure the phone is off.

  • Use the T5 screwdriver to remove the two 8.6mm long screws, located at the bottom of the phone. (Head size is 2.5mm)

Aggiungi Commento

Use the smallest Torx screwdriver or another small poking tool and push into the hole on the SIM card slot. The plastic SIM protective piece should pop out quite easily. Put that plastic piece aside.
  • Use the smallest Torx screwdriver or another small poking tool and push into the hole on the SIM card slot. The plastic SIM protective piece should pop out quite easily.

  • Put that plastic piece aside.

Aggiungi Commento

Once both screws on the bottom are removed, and the plastic SIM protective piece is removed, gently push on the outside of the screen. The screen should become separated using little force. And should like the pictures shown once complete.
  • Once both screws on the bottom are removed, and the plastic SIM protective piece is removed, gently push on the outside of the screen.

  • The screen should become separated using little force. And should like the pictures shown once complete.

Aggiungi Commento

This step may be easier to remove the battery first, but it is not mandatory. Place the spudger tool or flat plastic tool on top of the ribbon cable to avoid damaging it when prying up on the metal clip.
  • This step may be easier to remove the battery first, but it is not mandatory.

  • Place the spudger tool or flat plastic tool on top of the ribbon cable to avoid damaging it when prying up on the metal clip.

  • Use a plastic opening tool, or gently use a small metal flat-head screwdriver to pry up the metal clip. (It is recommended to use a plastic tool; However, if the opening tool does not work or fit into the small opening underneath the clip, use the flat-head.)

Aggiungi Commento

Once the metal clip is removed, gently pry up on the ribbon cable connection, located underneath the metal clip you have just removed. Once the metal clip is removed, gently pry up on the ribbon cable connection, located underneath the metal clip you have just removed.
  • Once the metal clip is removed, gently pry up on the ribbon cable connection, located underneath the metal clip you have just removed.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 12 persone hanno completato questa guida.

Jonathan

Membro da: 31/10/2014

1.411 Reputazione

4 Guide realizzate

Team

UMass Dartmouth, Team 4-2, Miles Fall 2014 Membro di UMass Dartmouth, Team 4-2, Miles Fall 2014

UMASSD-MILES-F14S4G2

2 Membri

4 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 43

Tutti i Tempi: 8,241