Introduzione

If there is a power problem, you may need to reattach wires to the battery compartment or replace it completely. If the problem is Corrosion, just see the guide on corrosion.

  • In this guide we will be referring to 'left' and 'right' as though the camera's front (the part that says Nikon) is facing you.

  • Unscrew the large metal screw on the left side using a quarter and remove the battery cover.(Picture not available)

Aggiungi Commento

Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.
  • Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.

Aggiungi Commento

Pull up on the tab to remove the batteries.
  • Pull up on the tab to remove the batteries.

  • Note: The batteries will probably fall out of their holder.

Aggiungi Commento

Use a 00 Phillips head screwdriver to remove the four screws from inside the case.
  • Use a 00 Phillips head screwdriver to remove the four screws from inside the case.

Aggiungi Commento

Remove the battery compartment from the camera.
  • Remove the battery compartment from the camera.

  • Note: On some models, the compartment is soldered in by the wires shown. If so you will need to desolder them.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Zachary Phillips

Membro da: 08/04/2011

178 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 25-26, Garner Spring 2011 Membro di Cal Poly, Team 25-26, Garner Spring 2011

CPSU-GARNER-S11S25G26

3 Membri

6 Guide realizzate

Hey, i lost the bracket… do u guys have any idea where could i get one?

David mate - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 18

Ultimi 30 Giorni: 107

Tutti i Tempi: 8,861