Introduzione

This guide will help to you access your viewfinder in your Nikon D40 and replace the viewfinder.

Parti

Nessuna parte richiesta.

Remove the two visible 6.0 mm Philips #0 screws on the left and right sides of the viewfinder. These screws are highlighted in red.
  • Remove the two visible 6.0 mm Philips #0 screws on the left and right sides of the viewfinder. These screws are highlighted in red.

Aggiungi Commento

Remove the four 6.0 mm Philips #0 screws on the left and right sides of the camera. Remove the four 6.0 mm Philips #0 screws on the left and right sides of the camera.
  • Remove the four 6.0 mm Philips #0 screws on the left and right sides of the camera.

Aggiungi Commento

Remove the four highlighted 3.0 mm Philips #0 screws on the bottom of the camera.
  • Remove the four highlighted 3.0 mm Philips #0 screws on the bottom of the camera.

Worth mentioning, the top circled screw was a 6mm on my camera. The other 3 were 3mm.

Mark Brown - Replica

While pulling the bottom down, remove the back of the camera.
  • While pulling the bottom down, remove the back of the camera.

  • Be careful not to pull too hard on the back as it is connected via a ribbon cable. Be sure to disconnect this cable on the main board.

  • To disconnect the ribbon cable pull the small black tab upward and pull gently on the cable.

Aggiungi Commento

You will be able to see the ribbon cables coming out from the back panel, disconnect the cables.
  • You will be able to see the ribbon cables coming out from the back panel, disconnect the cables.

  • Be careful not to pull too hard on the ribbon cables.

Aggiungi Commento

Slowly push the upper body up until you see the frame of the viewfinder
  • Slowly push the upper body up until you see the frame of the viewfinder

  • Be careful while pulling the top camera body.

Aggiungi Commento

Use a spudger to keep the upper body separate from the printed circuit board.
  • Use a spudger to keep the upper body separate from the printed circuit board.

  • Wiggle the plastic eyepiece out of the frame. This may require some force.

Aggiungi Commento

Remove the viewfinder with the plastic opening tool.
  • Remove the viewfinder with the plastic opening tool.

  • Do not push too hard while using the opening tool.

Aggiungi Commento

The viewfinder has been removed!
  • The viewfinder has been removed!

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Amy Chen

Membro da: 23/01/2014

177 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 6-19, Maness Winter 2014 Membro di Cal Poly, Team 6-19, Maness Winter 2014

CPSU-MANESS-W14S6G19

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 33

Tutti i Tempi: 1,895