Introduzione

This guide will walk you through the necessary steps to remove the back panel of the Nikon Coolpix E5700.

Parti

Nessuna parte richiesta.

Use your finger tip to slide the battery release tab toward the battery symbol on the E5700. Open the battery door.
  • Use your finger tip to slide the battery release tab toward the battery symbol on the E5700.

  • Open the battery door.

Aggiungi Commento

Pull the battery out of the E5700.
  • Pull the battery out of the E5700.

  • It may be necessary to wiggle the battery while pulling to free it from its pocket in the case.

Aggiungi Commento

Turn to the bottom of the camera.
  • Turn to the bottom of the camera.

  • Remove the two Phillips screws located directly below the back monitor

Aggiungi Commento

Turn the camera to the side with the memory card slot and open the compartment for the CF card. Remove the top two Phillips screws closest to the back panel.
  • Turn the camera to the side with the memory card slot and open the compartment for the CF card.

  • Remove the top two Phillips screws closest to the back panel.

Aggiungi Commento

Turn to the back of the camera.
  • Turn to the back of the camera.

  • Remove the top most Phillips screw on the back panel.

Aggiungi Commento

Turn to the last side of the back panel.
  • Turn to the last side of the back panel.

  • Remove the Phillips screw below the eyepiece.

  • Remove the Phillips screw located above the speaker.

Aggiungi Commento

Gently begin to remove the back panel. Caution: There are two bundles of wires connecting the back panel to the camera. Be sure not to pull too hard and yank these out.
  • Gently begin to remove the back panel.

    • Caution: There are two bundles of wires connecting the back panel to the camera. Be sure not to pull too hard and yank these out.

Before pulling the panel. You MUST remove first de rubber bumper ( arrond the ocular piece ).

diego - Replica

Now gently unplug the two wires at the bottom of the panel. Now gently unplug the two wires at the bottom of the panel.
  • Now gently unplug the two wires at the bottom of the panel.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Raana

Membro da: 12/04/2011

57 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 24-58, Amido Spring 2011 Membro di Cal Poly, Team 24-58, Amido Spring 2011

CPSU-AMIDO-S11S24G58

4 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 9

Tutti i Tempi: 1,666