Introduzione

Replacing the front cover of a Nikon Coolpix 3500.

Parti

Nessuna parte richiesta.

Unlatch the battery cover. Slide the cover out and flip it open.
  • Unlatch the battery cover. Slide the cover out and flip it open.

  • Remove the battery.

  • Gently remove the battery cover.

Aggiungi Commento

Remove the two 4.5 mm screws that sit next to the battery slot.
  • Remove the two 4.5 mm screws that sit next to the battery slot.

  • Remove the 3 mm screw that sits below the CF card slot.

  • Remove the 4.5 mm screw that sits above the digital I/O cover.

Aggiungi Commento

Remove the two 4.5 mm screws that sit inside the battery slot.
  • Remove the two 4.5 mm screws that sit inside the battery slot.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Remove the two 5 mm screws that sit near the camera strap eyelet.
  • Remove the two 5 mm screws that sit near the camera strap eyelet.

  • Remove the camera strap eyelet.

Aggiungi Commento

Remove the 5 mm screw and cap that were underneath the camera strap eyelet.
  • Remove the 5 mm screw and cap that were underneath the camera strap eyelet.

Aggiungi Commento

Remove the five 3.5 mm screws that sit at the bottom of the camera. Remove the grey plastic piece, which the five screws held in place, by gently detaching the front cover.
  • Remove the five 3.5 mm screws that sit at the bottom of the camera.

  • Remove the grey plastic piece, which the five screws held in place, by gently detaching the front cover.

  • Do not apply too much force; two wires still connect the front cover to the logic board.

Aggiungi Commento

Using a spudger, detach the white-capped wire. Using a spudger, detach the orange-capped wire and set the front cover aside.
  • Using a spudger, detach the white-capped wire.

  • Using a spudger, detach the orange-capped wire and set the front cover aside.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

richard guenther

Membro da: 19/04/2010

183 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 30-38, Garner Spring 2010 Membro di Cal Poly, Team 30-38, Garner Spring 2010

CPSU-GARNER-S10S30G38

5 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 2

Tutti i Tempi: 1,685