Introduzione

Replacement of the TF6's dust cover is necessary when it is cracked or broken. Replacement dust covers can be obtained from any Mr. Coffee TF series coffeemaker or online at Mr. Coffee's website.

Strumenti

Nessun attrezzo richiesto.

Parti

Facing the front of the TF6, gently lift the dust cover along its hinge until it reaches its designed stopping point. Facing the front of the TF6, gently lift the dust cover along its hinge until it reaches its designed stopping point.
  • Facing the front of the TF6, gently lift the dust cover along its hinge until it reaches its designed stopping point.

Aggiungi Commento

Orient the retaining bracket upwards (away from the main body of unit). Do not push the retaining bracket beyond its designed range of motion. It may snap if too much force is applied outside its limit.
  • Orient the retaining bracket upwards (away from the main body of unit).

  • Do not push the retaining bracket beyond its designed range of motion. It may snap if too much force is applied outside its limit.

Aggiungi Commento

With the retaining clip in its released position, pull the spout down towards the filter basket.
  • With the retaining clip in its released position, pull the spout down towards the filter basket.

Aggiungi Commento

Carefully detach the dust cover by disengaging the locking pins, starting at one side. Extra force may be required to disengage the dust cover's locking pins. Refrain from applying excessive upward force on the dust cover, as dong so may cause the pins to snap under pressure.
  • Carefully detach the dust cover by disengaging the locking pins, starting at one side.

  • Extra force may be required to disengage the dust cover's locking pins. Refrain from applying excessive upward force on the dust cover, as dong so may cause the pins to snap under pressure.

Aggiungi Commento

Conclusione

Follow these steps in reverse order with a new Dust Cover.

Jordan

Membro da: 31/01/2014

201 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 13-18, Regan Winter 2014 Membro di Cal Poly, Team 13-18, Regan Winter 2014

CPSU-REGAN-W14S13G18

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 2

Tutti i Tempi: 244