Salta al contenuto principale

Motorola syn1654A Headphone Speaker Replacement

Cosa ti serve

  1. Motorola syn1654A Headphone Speaker Replacement, Headphone Speaker: passo 1, immagine 1 di 1
    • Make sure the headphones are off and unplugged from any devices.

    • Remove leather headphone cushion by pulling edge towards middle of headphone.

    • It should slip off the device.

  2. Motorola syn1654A Headphone Speaker Replacement: passo 2, immagine 1 di 1
    • Carefully peel back foam pad to prevent tearing.

    • It is glued at both the top and bottom.

  3. Motorola syn1654A Headphone Speaker Replacement: passo 3, immagine 1 di 1
    • Use the T6 torx screwdriver to remove the three screws holding the speaker in place.

    • To avoid stripping screws, be sure to use the right screw bit oriented perpendicular to the face of the screw.

  4. Motorola syn1654A Headphone Speaker Replacement: passo 4, immagine 1 di 1
    • With the speaker removed from the speaker module, clip the black and white wires on the back of the speaker, as shown.

    • Solder wires onto corresponding pads of replacement speaker.

    • For soldering see the ifixit soldering guide: Come saldare e dissaldare componenti elettrici

Conclusione

To reassemble your device, follow these instructions in reverse order.

John Ware

Membro da: 02/24/14

325 Reputazione

2 Guide realizzate

Team

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 386