Introduzione

Use this repair guide to replace an SD card in a Motorola RAZR2 v9m.

Strumenti

Nessun attrezzo richiesto.

Parti

Nessuna parte richiesta.

Push the rear cover toward the hinge of the RAZR2.  The panel will slide about 3 mm. Push the rear cover toward the hinge of the RAZR2.  The panel will slide about 3 mm.
  • Push the rear cover toward the hinge of the RAZR2. The panel will slide about 3 mm.

Aggiungi Commento

Pinch the top and bottom edges of the panel and pull it away from the RAZR2. The rear panel uses four small hooks to hold it in place.  If the panel will not easily pull away, slide the panel more toward the hinge. The rear panel uses four small hooks to hold it in place.  If the panel will not easily pull away, slide the panel more toward the hinge.
  • Pinch the top and bottom edges of the panel and pull it away from the RAZR2.

  • The rear panel uses four small hooks to hold it in place. If the panel will not easily pull away, slide the panel more toward the hinge.

Aggiungi Commento

Gently pull the white plastic tab to lift the battery away from the RAZR2. The white plastic tab is attached to the phone.  Only pull it enough to expose the edges of the battery.
  • Gently pull the white plastic tab to lift the battery away from the RAZR2.

  • The white plastic tab is attached to the phone. Only pull it enough to expose the edges of the battery.

Aggiungi Commento

To remove the battery, grasp its edges pull away from the phone. When installing a new battery, be sure the metal contacts on the phone line up with the ones on the battery.
  • To remove the battery, grasp its edges pull away from the phone.

  • When installing a new battery, be sure the metal contacts on the phone line up with the ones on the battery.

Aggiungi Commento

Press the exposed portion of the SD card towards the bottom of the phone until you hear a click. The SD card will slide into the phone about 10 mm. Press the exposed portion of the SD card towards the bottom of the phone until you hear a click. The SD card will slide into the phone about 10 mm.
  • Press the exposed portion of the SD card towards the bottom of the phone until you hear a click. The SD card will slide into the phone about 10 mm.

Aggiungi Commento

Release the SD card. A spring will push it partially out of the phone. Grasp the card by the edges and remove.
  • Release the SD card. A spring will push it partially out of the phone.

  • Grasp the card by the edges and remove.

  • When installing a new SD card, remember that it must be 2 GB or less.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 450