Introduzione

Being able to access the LCD display of your Motorola Q Global is important if you wish to do self-maintenance. Here, we show you how to do so.

Parti

Nessuna parte richiesta.

Turn the phone face down.
  • Turn the phone face down.

  • Press and hold the release button in the middle of the back panel.

  • Slide the bottom panel down to remove.

Aggiungi Commento

Remove the battery pack by prying it out with a fingernail, screw driver or other opening tool at the tab shown. When reinserting the battery, make sure the contacts in the battery are lined up with the contacts in the phone.
  • Remove the battery pack by prying it out with a fingernail, screw driver or other opening tool at the tab shown.

  • When reinserting the battery, make sure the contacts in the battery are lined up with the contacts in the phone.

Aggiungi Commento

Press inwardly on the upper casing to release.
  • Press inwardly on the upper casing to release.

Aggiungi Commento

Slide the upper case rightward and lift up.
  • Slide the upper case rightward and lift up.

  • Lift the camera sticker so that it does not get damaged.

Aggiungi Commento

Remove the 6 screws using the T5 torx screwdriver. Remove the 6 screws using the T5 torx screwdriver.
  • Remove the 6 screws using the T5 torx screwdriver.

Aggiungi Commento

Once the screws are removed, use the plastic opening tool to remove the black casing.
  • Once the screws are removed, use the plastic opening tool to remove the black casing.

Aggiungi Commento

Remove both screws on the mounted surface with a T5 screwdriver. Remove both screws on the mounted surface with a T5 screwdriver.
  • Remove both screws on the mounted surface with a T5 screwdriver.

Aggiungi Commento

Remove the glued, mounted surface by lifting it from underneath the SIM card slot by using the plastic opening tool. Remove the glued, mounted surface by lifting it from underneath the SIM card slot by using the plastic opening tool.
  • Remove the glued, mounted surface by lifting it from underneath the SIM card slot by using the plastic opening tool.

Aggiungi Commento

Lift the motherboard about 90 degrees and remove the circuit with the orange ribbon (from the keyboard) by gently lifting the circuit. Lift the motherboard about 90 degrees and remove the circuit with the orange ribbon (from the keyboard) by gently lifting the circuit.
  • Lift the motherboard about 90 degrees and remove the circuit with the orange ribbon (from the keyboard) by gently lifting the circuit.

Aggiungi Commento

Separate the front plate from the circuit board. The LCD screen is attached to the circuit board by a thin ribbon.
  • Separate the front plate from the circuit board.

  • The LCD screen is attached to the circuit board by a thin ribbon.

  • Switch the lock on top of the circuit entry from horizontal to vertical.

Aggiungi Commento

Insert the new LCD screen into the circuit.
  • Insert the new LCD screen into the circuit.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Will Dickman

Membro da: 27/09/2012

28 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 6-31, Regan Fall 2012 Membro di Cal Poly, Team 6-31, Regan Fall 2012

CPSU-REGAN-F12S6G31

5 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 712