Introduzione

Replace the camera for your Motorola MOTO phone.

Using your finger, press down on the clip holding the back cover on Pull the back cover off.
  • Using your finger, press down on the clip holding the back cover on

  • Pull the back cover off.

Aggiungi Commento

Place thumb and index finger in the spaces on either side of the battery. Pull battery out.
  • Place thumb and index finger in the spaces on either side of the battery.

  • Pull battery out.

Aggiungi Commento

Use the plastic opening tool to pull peel back screen cover. Gently peel back the screen cover from the speaker slit. Using the T6 Torx-screwdriver, remove the four 4.3 mm screws from the top panel.
  • Use the plastic opening tool to pull peel back screen cover.

  • Gently peel back the screen cover from the speaker slit.

  • Using the T6 Torx-screwdriver, remove the four 4.3 mm screws from the top panel.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Using the flat end of the plastic opening tool, insert it underneath the plastic cover on the top right corner. Move the opening tool around the phone counter clockwise. Pop the plastic cover off by twisting the plastic covering tool.
  • Using the flat end of the plastic opening tool, insert it underneath the plastic cover on the top right corner.

  • Move the opening tool around the phone counter clockwise.

  • Pop the plastic cover off by twisting the plastic covering tool.

Aggiungi Commento

Using a flat head screwdriver, insert it between the metal logic board casing and the top portion of the phone Move the plastic opening tool around the phone until part of the casting is popped off.
  • Using a flat head screwdriver, insert it between the metal logic board casing and the top portion of the phone

  • Move the plastic opening tool around the phone until part of the casting is popped off.

  • You will need to pop in the four plastic fasteners individually from the metal casing to remove it

  • Be careful not to rip the cable ribbons that are attached to the logic board and casing

Aggiungi Commento

Use the flat end of the plastic opening tool to unclip the cable ribbon from the logic board
  • Use the flat end of the plastic opening tool to unclip the cable ribbon from the logic board

Aggiungi Commento

You now have the top panel completely detached.
  • You now have the top panel completely detached.

Aggiungi Commento

Using the plastic opening tool, peel back the plastic cover that is glued on top of the camera lens.
  • Using the plastic opening tool, peel back the plastic cover that is glued on top of the camera lens.

Aggiungi Commento

Using the plastic opening tool, gently push the camera out from the front. Part of the foam holding the camera will rip from the adhesive.
  • Using the plastic opening tool, gently push the camera out from the front.

  • Part of the foam holding the camera will rip from the adhesive.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

C Miller

Membro da: 25/06/2012

38 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 1-3, Regan SU 2012 Membro di Cal Poly, Team 1-3, Regan SU 2012

CPSU-REGAN-SU12S1G3

2 Membri

14 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 998