Introduzione

Use this guide to replace the pull-out antenna through the back of the device.

Parti

Nessuna parte richiesta.

Remove the battery by sliding it down the rails to which it is connected.
  • Remove the battery by sliding it down the rails to which it is connected.

Aggiungi Commento

Locate a Flat-head or a Phillips head screwdriver.
  • Locate a Flat-head or a Phillips head screwdriver.

  • Insert the screwdriver into the holes that connect the key pad guard to the rear casing in the plastic rod.

  • The following step may require a substantial amount of force.

  • Use the screwdriver to push the rods towards each other until they click out of their locked positions.

Aggiungi Commento

Slide off the antenna guard and locate the four clips on the exterior of the rear casing.
  • Slide off the antenna guard and locate the four clips on the exterior of the rear casing.

  • Simultaneously push the clips outward while lifting the rear casing and keyguard away from the front casing.

Aggiungi Commento

Locate and unplug the black component of the current antenna from the motherboard.
  • Locate and unplug the black component of the current antenna from the motherboard.

  • Under the black component should be a blue component. Unscrew this component in order to free the antenna.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Slide the antenna out of the green tubing.
  • Slide the antenna out of the green tubing.

  • Slide the green tubing out of its hole.

Aggiungi Commento

Insert the new green tubing into the corresponding slot.
  • Insert the new green tubing into the corresponding slot.

Aggiungi Commento

Insert the new antenna into the green tubing.
  • Insert the new antenna into the green tubing.

Aggiungi Commento

Screw the blue piece of the antenna into the threaded hole on the motherboard until it is tight.
  • Screw the blue piece of the antenna into the threaded hole on the motherboard until it is tight.

Aggiungi Commento

Align the protruding wire on the black component with the corresponding hole on the motherboard.
  • Align the protruding wire on the black component with the corresponding hole on the motherboard.

  • Push the wire into the hole.

Aggiungi Commento

Reverse the instructions from Step 2 to re-install the keypad guard and rear casing onto the device.
  • Reverse the instructions from Step 2 to re-install the keypad guard and rear casing onto the device.

Aggiungi Commento

Push down on the antenna guard until it clicks into place.
  • Push down on the antenna guard until it clicks into place.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Andrew Lam

Membro da: 17/04/2012

28 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 9-46, Regan Spring 2012 Membro di Cal Poly, Team 9-46, Regan Spring 2012

CPSU-REGAN-S12S9G46

5 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 5

Tutti i Tempi: 1,438