Aggiusta la tua roba Comunità Store

Mercedes W123 Brake/Tail/Reverse/Turn Bulb Replacement

Cosa ti serve

  1. Mercedes W123 Brake/Tail/Reverse/Turn Bulb Replacement, Tail/Reverse/Rear Turn Signal Bulb: passo 1, immagine 1 di 1

    • The access panel for all of these lights is on the inside of the trunk. There's one on each side. This guide will cover one side; simply repeat on the other to complete the job.

    Modifica

  2. Mercedes W123 Brake/Tail/Reverse/Turn Bulb Replacement: passo 2, immagine 1 di 1

    • The panel is secured with two thumb screws. Remove these.

    Modifica

  3. Mercedes W123 Brake/Tail/Reverse/Turn Bulb Replacement: passo 3, immagine 1 di 1

    • Pull the panel out and away from the back of the car, being careful not to force the bulbs out of the holes.

    Modifica

  5. Mercedes W123 Brake/Tail/Reverse/Turn Bulb Replacement: passo 4, immagine 1 di 1

    • There are five bulbs in each tail light housing. They are as follows:

    • Brake light

    • Reverse light

    • Tail light

    • Turn signal

    • Side marker

    Modifica

  6. Mercedes W123 Brake/Tail/Reverse/Turn Bulb Replacement: passo 5, immagine 1 di 1

    • To remove any of the bulbs simply turn them counter clockwise approximately a half turn and then pull them out of their socket.

    Modifica

  7. Mercedes W123 Brake/Tail/Reverse/Turn Bulb Replacement: passo 6, immagine 1 di 3 Mercedes W123 Brake/Tail/Reverse/Turn Bulb Replacement: passo 6, immagine 2 di 3 Mercedes W123 Brake/Tail/Reverse/Turn Bulb Replacement: passo 6, immagine 3 di 3

    • Three of the bulbs are #1156

    • One is a #96

    • One is a small 4W blub

    Modifica

  8. Mercedes W123 Brake/Tail/Reverse/Turn Bulb Replacement: passo 7, immagine 1 di 1

    • Before installing the new bulb consider cleaning the socket with a soft metal wire brush such as the brass brush shown to help remove any corrosion.

    • Then install the new bulb, reassemble the device, and finally, be sure to test that all of your rear lights are working before going for a drive.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 10 persone hanno completato questa guida.

Autore

Nicolas Siemsen

Membro da: 12/06/13

39.040 Reputazione

79 Guide realizzate

Distintivi: 30

+27 altri distintivi

Team

Master Techs Membro di Master Techs

Community

322 Membri

2.528 Guide realizzate

2 Commenti

Very informative, descriptive and point on analysis.

George T Peeke - Replica

Und wie wird dies beim Kombi gemacht?

srossius - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 15

Ultimi 30 Giorni: 92

Tutti i Tempi: 12,277