Salta al contenuto principale

Macintosh PowerBook 165c Keyboard Replacement

Cosa ti serve

  1. Macintosh PowerBook 165c Keyboard Replacement, Battery: passo 1, immagine 1 di 1
    • Orient the computer so the battery is facing you.

    • Slide the gray plastic battery cover to the right.

  2. Macintosh PowerBook 165c Keyboard Replacement: passo 2, immagine 1 di 1
    • Pull the battery toward yourself until it is fully detached.

  3. Macintosh PowerBook 165c Keyboard Replacement, Input/Output Door: passo 3, immagine 1 di 1
    • Orient the computer right side up with the rear facing you.

    • Open the Input/Output (I/O) door.

  4. Macintosh PowerBook 165c Keyboard Replacement: passo 4, immagine 1 di 1
    • Carefully bend the door into an arch until one of the pins releases from its slot.

    • Once one of the pins is free, remove the I/O door from the computer.

  5. Macintosh PowerBook 165c Keyboard Replacement, Lower Case: passo 5, immagine 1 di 1
    • Orient the computer with the bottom facing up and rear facing you. You should be able to read the Macintosh label in this position.

  6. Macintosh PowerBook 165c Keyboard Replacement: passo 6, immagine 1 di 1
    • Use a T8 torx screwdriver to remove the 6.8mm long screw above and to the right of the modem jack.

    • Twist counter clockwise to remove the screw.

  7. Macintosh PowerBook 165c Keyboard Replacement: passo 7, immagine 1 di 1
    • Use a T10 torx screwdriver to remove the four, 18mm long screws from the lower case.

  8. Macintosh PowerBook 165c Keyboard Replacement: passo 8, immagine 1 di 2 Macintosh PowerBook 165c Keyboard Replacement: passo 8, immagine 2 di 2
    • Place your hands on the lower case, just above the I/O panel, and slowly lift the lower case a few inches above the main body of the computer.

    • Release the large, gray interconnect ribbon cable just behind the I/O panel.

    • Caution: Lower case cannot be fully removed until two plastic clips in the front corners are released. See the following step for details.

  9. Macintosh PowerBook 165c Keyboard Replacement: passo 9, immagine 1 di 2 Macintosh PowerBook 165c Keyboard Replacement: passo 9, immagine 2 di 2
    • Place your thumb on the upper case, inside the empty battery slot, and your index finger near your thumb on the left side of the lower case.

    • Pinch your thumb and index finger towards each other to release the clip. Without releasing pressure on the pinch grip, use your index finger to push the lower case upwards.

    • Lift the lower case to remove it.

  10. Macintosh PowerBook 165c Keyboard Replacement, Trackball: passo 10, immagine 1 di 2 Macintosh PowerBook 165c Keyboard Replacement, Trackball: passo 10, immagine 2 di 2
    • Locate the trackball assembly. It is in the upper case and can be identified by a green circuit board.

    • Open the white tab fastener by pulling out on each side. and remove the green and silver ribbon cable.

    • Remove the green and silver ribbon cable by gently pulling it away from the opened tab fastener.

  11. Macintosh PowerBook 165c Keyboard Replacement: passo 11, immagine 1 di 1
    • Use a T8 torx screwdriver to remove the six, 6.8mm long screws from the top of the green circuit board.

  12. Macintosh PowerBook 165c Keyboard Replacement: passo 12, immagine 1 di 1
    • Remove all four components of the trackball assembly by lifting upward.

    • The four components of the trackball assembly should include: the green circuit board, a metal support, the track ball, and the casing.

  13. Macintosh PowerBook 165c Keyboard Replacement, Keyboard: passo 13, immagine 1 di 2 Macintosh PowerBook 165c Keyboard Replacement, Keyboard: passo 13, immagine 2 di 2
    • Open the left most white tab fastener in the lower left corner by pulling up on each side.

    • Remove the ribbon cable by gently pulling it away from the opened tab fastener.

  14. Macintosh PowerBook 165c Keyboard Replacement: passo 14, immagine 1 di 2 Macintosh PowerBook 165c Keyboard Replacement: passo 14, immagine 2 di 2
    • Open the right of the two small, white tab fasteners by pulling up on both sides.

    • Remove the green and silver ribbon cable from the tab fastener.

  15. Macintosh PowerBook 165c Keyboard Replacement: passo 15, immagine 1 di 1
    • Use a T8 torx screwdriver to remove the seven, 6.8mm long screws from the metallic panel.

  16. Macintosh PowerBook 165c Keyboard Replacement: passo 16, immagine 1 di 1
    • Remove the keyboard by lifting it vertically away from the main body of the computer.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Adam

Membro da: 10/12/11

1 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 6-3, Regan Fall 2011 Membro di Cal Poly, Team 6-3, Regan Fall 2011

CPSU-REGAN-F11S6G3

4 Membri

12 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 6

Tutti i Tempi: 854