Introduzione

Reclaim your singular source of internet connectivity by replacing your broken AirPort/Bluetooth board.

Unplug your MacBook Air and power it off before you proceed.
  • Unplug your MacBook Air and power it off before you proceed.

  • Remove ten Phillips screws securing the lower case to the MacBook Air:

    • Six 2.8 mm screws

    • Two 3.8 mm screws

    • Two 5.4 mm screws

Aggiungi Commento

Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs. Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.
  • Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.

Aggiungi Commento

Disconnect the battery connector by pulling it straight out of its socket.
  • Disconnect the battery connector by pulling it straight out of its socket.

Aggiungi Commento

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Remove the following nine screws securing the battery to the Air:
  • Remove the following nine screws securing the battery to the Air:

    • Four 2.9 mm Phillips.

    • Four 3.8 mm Phillips.

    • One 7.2 mm Phillips.

Aggiungi Commento

Lift the battery out of the Air.
  • Lift the battery out of the Air.

Aggiungi Commento

Remove the two following screws securing the AirPort/Bluetooth board bracket to the upper case: One 4.7 mm Phillips.
  • Remove the two following screws securing the AirPort/Bluetooth board bracket to the upper case:

    • One 4.7 mm Phillips.

    • One 3.9 mm Phillips.

  • Lift the AirPort/Bluetooth bracket out of the upper case.

Aggiungi Commento

Using a spudger, pry the AirPort/Bluetooth ribbon cable connector straight up off the AirPort/Bluetooth board.
  • Using a spudger, pry the AirPort/Bluetooth ribbon cable connector straight up off the AirPort/Bluetooth board.

Aggiungi Commento

Use a spudger to pry the three antenna cables up off the AirPort/Bluetooth board.
  • Use a spudger to pry the three antenna cables up off the AirPort/Bluetooth board.

Aggiungi Commento

Remove the single 3.2 mm Phillips screw from the upper right corner of the AirPort/Bluetooth board. Lift the AirPort/Bluetooth board out of the upper case.
  • Remove the single 3.2 mm Phillips screw from the upper right corner of the AirPort/Bluetooth board.

  • Lift the AirPort/Bluetooth board out of the upper case.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 9 persone hanno completato questa guida.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 5

Ultimi 7 Giorni: 26

Ultimi 30 Giorni: 109

Tutti i Tempi: 33,848