Aggiusta la tua roba Comunità Store

MacBook Air 11" Late 2010 AirPort/Bluetooth Card Replacement

Introduzione

Use this guide to replace your MacBook Air's AirPort/Bluetooth card.

Cosa ti serve

  1. MacBook Air 11" Late 2010 AirPort/Bluetooth Card Replacement, Lower Case: passo 1, immagine 1 di 1
    Attrezzo utilizzato in questo passaggio:
    P5 Pentalobe Screwdriver Retina MacBook Pro and Air
    $5.99
    Compra

    • Before proceeding, close your computer and lay it on a soft surface top-side down.

    • Remove the following ten screws:

    • Two 8 mm 5-point Pentalobe screws

    • Eight 2.5 mm 5-point Pentalobe screws

    • The special screwdriver needed to remove the eight 5-point Pentalobe screws can be found here.

    Traduci

  2. MacBook Air 11" Late 2010 AirPort/Bluetooth Card Replacement: passo 2, immagine 1 di 1

    • Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

    • Remove the lower case and set it aside.

    Traduci

  4. MacBook Air 11" Late 2010 AirPort/Bluetooth Card Replacement, Battery: passo 3, immagine 1 di 2 MacBook Air 11" Late 2010 AirPort/Bluetooth Card Replacement, Battery: passo 3, immagine 2 di 2

    • In this step you will disconnect the battery to help avoid shorting out any components during service.

    • Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.

    • Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.

    Traduci

  5. MacBook Air 11" Late 2010 AirPort/Bluetooth Card Replacement, AirPort/Bluetooth Card: passo 4, immagine 1 di 2 MacBook Air 11" Late 2010 AirPort/Bluetooth Card Replacement, AirPort/Bluetooth Card: passo 4, immagine 2 di 2

    • Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card.

    Traduci

  6. MacBook Air 11" Late 2010 AirPort/Bluetooth Card Replacement: passo 5, immagine 1 di 1

    • Remove the single 2.9 mm T5 Torx screw securing the AirPort/Bluetooth card to the logic board.

    Traduci

  7. MacBook Air 11" Late 2010 AirPort/Bluetooth Card Replacement: passo 6, immagine 1 di 2 MacBook Air 11" Late 2010 AirPort/Bluetooth Card Replacement: passo 6, immagine 2 di 2

    • Slightly lift the free end of the AirPort/Bluetooth board and pull it out of its socket on the logic board.

    • Remove the AirPort/Bluetooth board from the Air.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 11 persone hanno completato questa guida.

Un commento

Hi Andrew, thanks for your guide on MacBook Air 11" Late 2010 Airport-Bluetooth Card. I am desperately trying to purchase new cables with female connectors to connect to the Card's male jacks. I ignore the size which is important: I tried MHF 4 too small, MHF 1 too big, so before buying wrong cables again I wonder if you can tell me what size is the Card's jack connection. I thank you for your help in advance.

Max

Massimo Bazzano - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 13

Ultimi 30 Giorni: 31

Tutti i Tempi: 23,164