Introduzione

In this guide you will remove the router's front case and begin to have access to the router's internal components.

Turn the router over so that all four of its feet are facing upwards.
  • Turn the router over so that all four of its feet are facing upwards.

Aggiungi Commento

Remove the rubber inserts inside the the two purple feet located on the router's front case.
  • Remove the rubber inserts inside the the two purple feet located on the router's front case.

  • This may be a challenge, so try the following two methods:

    • Use a plastic opening tool. Insert the flat end of the tool into the seam and slowly pry the rubber feet out.

    • Use a metal spudger. Insert the point of the metal spudger directly into the hole of the rubber feet and pry the insert out.

Aggiungi Commento

Use a Phillips #2 Screwdriver to remove the two 5.8 mm screws holding the front case to the motherboard.
  • Use a Phillips #2 Screwdriver to remove the two 5.8 mm screws holding the front case to the motherboard.

Aggiungi Commento

Squeeze the sides of the router's backcase inward and pull off the purple front case. It is helpful to have a second person assist you for this step.
  • Squeeze the sides of the router's backcase inward and pull off the purple front case. It is helpful to have a second person assist you for this step.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Allian Roman

Membro da: 12/10/2011

248 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 3-4, Regan Fall 2011 Membro di Cal Poly, Team 3-4, Regan Fall 2011

CPSU-REGAN-F11S3G4

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 878