Parti

Nessuna parte richiesta.

Turn the phone off. Remove the back cover by sliding the tab away from the phone using one finger.
  • Turn the phone off.

  • Remove the back cover by sliding the tab away from the phone using one finger.

Aggiungi Commento

Lift one side of the battery using a plastic opening tool or your fingers.
  • Lift one side of the battery using a plastic opening tool or your fingers.

  • Carefully remove the battery and set it aside.

Aggiungi Commento

When installing the battery, make sure to align the metal pins with those of the phone.
  • When installing the battery, make sure to align the metal pins with those of the phone.

Aggiungi Commento

Use a Phillips #0 Screwdriver to remove the nine 4 mm screws from the back cover. Use a Phillips #0 Screwdriver to remove the nine 4 mm screws from the back cover.
  • Use a Phillips #0 Screwdriver to remove the nine 4 mm screws from the back cover.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Insert the tip of the plastic opening tool into the small notch on the side of the case. Slide the opening tool along the seam and around the edge of the phone to separate the case.
  • Insert the tip of the plastic opening tool into the small notch on the side of the case.

    • Slide the opening tool along the seam and around the edge of the phone to separate the case.

Aggiungi Commento

Separate the two halves of the phone.
  • Separate the two halves of the phone.

    • On the left is the back of the phone holding the logic board and key pad.

    • On the right is the plastic casing.

Aggiungi Commento

Holding  the phone casing with one hand, and the key pad assembly with the other, separate the phone case from the keypad/logic board. Holding  the phone casing with one hand, and the key pad assembly with the other, separate the phone case from the keypad/logic board. Holding  the phone casing with one hand, and the key pad assembly with the other, separate the phone case from the keypad/logic board.
  • Holding the phone casing with one hand, and the key pad assembly with the other, separate the phone case from the keypad/logic board.

Aggiungi Commento

Remove the key pad from the logic board by pulling the two boards apart, separating this connection. Remove the key pad from the logic board by pulling the two boards apart, separating this connection.
  • Remove the key pad from the logic board by pulling the two boards apart, separating this connection.

Aggiungi Commento

First, pull back the tape covering the connection between the motherboard and the ribbon cable.
  • First, pull back the tape covering the connection between the motherboard and the ribbon cable.

  • Separate the connection, using the plastic opening tool.

Aggiungi Commento

After the connection is removed, the motherboard is successfully removed. After the connection is removed, the motherboard is successfully removed.
  • After the connection is removed, the motherboard is successfully removed.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Stanley Thomas

Membro da: 20/01/2012

38 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 8-16, Maness Winter 2012 Membro di Cal Poly, Team 8-16, Maness Winter 2012

CPSU-MANESS-W12S8G16

4 Membri

14 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,100