Turn the phone off. Remove the back cover by sliding the tab away from the phone using one finger.
  • Turn the phone off.

  • Remove the back cover by sliding the tab away from the phone using one finger.

Aggiungi Commento

Lift one side of the battery using a plastic opening tool or your fingers.
  • Lift one side of the battery using a plastic opening tool or your fingers.

  • Carefully remove the battery and set it aside.

Aggiungi Commento

When installing the battery, make sure to align the metal pins with those of the phone.
  • When installing the battery, make sure to align the metal pins with those of the phone.

Aggiungi Commento

Turn your phone around and open the flip phone.
  • Turn your phone around and open the flip phone.

  • Locate the two grey rubber plugs on the LCD portion of the phone. These plugs cover up two screws.

  • Remove the two grey screw-covers at the bottom of the screen

Aggiungi Commento

Remove the screen by using the tab to eject the screen. There is a gap between the case and the screen near the ear piece
  • Remove the screen by using the tab to eject the screen.

    • There is a gap between the case and the screen near the ear piece

    • Insert the plastic opening tool in the gap and pry the screen up.

  • The plastic screen cover is glued onto the phone, do not be alarmed if it may be difficult to pry it off.

Aggiungi Commento

Unscrew the four corner 3.21mm screws to separate the the top cover of the phone
  • Unscrew the four corner 3.21mm screws to separate the the top cover of the phone

Aggiungi Commento

Turn your phone around Remove the top cover of the phone by inserting the plastic opening tool into the groove.
  • Turn your phone around

  • Remove the top cover of the phone by inserting the plastic opening tool into the groove.

  • Carefully open the cover.

Aggiungi Commento

Desolder the top ear piece using a soldering iron to remove the component
  • Desolder the top ear piece using a soldering iron to remove the component

  • The ear piece is the black component that is located at the top with black and red wires

Aggiungi Commento

Remove the ear piece from the phone by lifting it using a plastic opening tool. Remove the ear piece from the phone by lifting it using a plastic opening tool.
  • Remove the ear piece from the phone by lifting it using a plastic opening tool.

Aggiungi Commento

Desolder the wires connected to the LCD board using a soldering iron
  • Desolder the wires connected to the LCD board using a soldering iron

Aggiungi Commento

Disconnect the Ribbon connecting the two pieces carefully with the plastic opening tool.
  • Disconnect the Ribbon connecting the two pieces carefully with the plastic opening tool.

Aggiungi Commento

Remove the LCD screen.
  • Remove the LCD screen.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Stanley Thomas

Membro da: 20/01/2012

38 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 8-16, Maness Winter 2012 Membro di Cal Poly, Team 8-16, Maness Winter 2012

CPSU-MANESS-W12S8G16

4 Membri

14 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 2

Tutti i Tempi: 1,348