Introduzione

This guide explain step by step how to replace the battery of your LG Optimus G with a couple of tools.

SIM eject tool SIM eject tool
  • SIM eject tool

Aggiungi Commento

Remove the 2 screws holding the back cover using a T5 screwdriver. Use a guitar pick or a plastic opening tool to free the clips on the top and each side of the back cover.
  • Remove the 2 screws holding the back cover using a T5 screwdriver.

  • Use a guitar pick or a plastic opening tool to free the clips on the top and each side of the back cover.

Aggiungi Commento

  • Use an opening pick to pry off the rear case.

Aggiungi Commento

Remove the tape over the battery, the screws and the antenna connector cord. Be careful removing the golden tape because it is below the antenna connector cord.
  • Remove the tape over the battery, the screws and the antenna connector cord.

  • Be careful removing the golden tape because it is below the antenna connector cord.

Aggiungi Commento

Remove the the screws securing the battery cable connector. Disconnect the battery cable.
  • Remove the the screws securing the battery cable connector.

  • Disconnect the battery cable.

Aggiungi Commento

The battery is held down by some adhesive.
  • The battery is held down by some adhesive.

  • Carefully heat the battery to loosen the adhesive holding it to the case.

Aggiungi Commento

Pry the battery up from the case. Be very careful not to puncture the battery when prying. Use blunt plastic tools.
  • Pry the battery up from the case.

  • Be very careful not to puncture the battery when prying. Use blunt plastic tools.

Aggiungi Commento

The battery is removed. Replace the battery with a new one. Replace the battery with a new one.
  • The battery is removed.

  • Replace the battery with a new one.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 6 persone hanno completato questa guida.

Eneider Colina

Membro da: 20/09/2013

1.005 Reputazione

7 Guide realizzate

“Heat gun”is too vague. So is IR thermometer. What temperature to soften adhesive? How would I know if I was buying the right things?

Deep - Replica

I’m not using a heat gun, it´s a hairdryer; on this case the hairdryer hardly exceeds the 60°C and that is enough to remove the battery. If you want to buy a heat gun you must be careful not to use more than 50 °

Eneider Colina - Replica

Where do you suggest ordering a replacement battery from?

snack le - Replica

you can search it on Amazon and buy directly from LG.

Eneider Colina -

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 24

Ultimi 30 Giorni: 85

Tutti i Tempi: 3,462