Introduzione

This guide will help you through the process of replacing the LG Muziq's keypad.

Parti

Nessuna parte richiesta.

Slide the battery cover release towards top of phone. Place one finger at each side of the battery cover.
  • Slide the battery cover release towards top of phone.

  • Place one finger at each side of the battery cover.

  • Lift and remove the battery cover.

Aggiungi Commento

Place a finger at the top corner of the battery and lift out of the phone. Place a finger at the top corner of the battery and lift out of the phone.
  • Place a finger at the top corner of the battery and lift out of the phone.

Aggiungi Commento

Use the spudger to lift up the two screw covers at the top of the phone. Remove all four Phillips#00 (3.3mm) screws with screwdriver.
  • Use the spudger to lift up the two screw covers at the top of the phone.

  • Remove all four Phillips#00 (3.3mm) screws with screwdriver.

Aggiungi Commento

Use the spudger to lift up the rear case from the phone. Note: Rear case is connected on all sides and will have to be detached on all sides before removal. Remove the rear case from the device.
  • Use the spudger to lift up the rear case from the phone.

  • Note: Rear case is connected on all sides and will have to be detached on all sides before removal.

  • Remove the rear case from the device.

Aggiungi Commento

Use the spudger to lift the motherboard from the phone. Use the spudger to lift the motherboard from the phone. Use the spudger to lift the motherboard from the phone.
  • Use the spudger to lift the motherboard from the phone.

Aggiungi Commento

Caution: The circuit board is connected via ribbon to the phone. Do not break this connection. Note: The circuit board is attached by clips on both sides of the board. Detach each clip before removing the motherboard from the phone. Use the spudger to detach the circuit board from the phone.
  • Caution: The circuit board is connected via ribbon to the phone. Do not break this connection.

  • Note: The circuit board is attached by clips on both sides of the board. Detach each clip before removing the motherboard from the phone.

  • Use the spudger to detach the circuit board from the phone.

Aggiungi Commento

Open the phone to expose the keypad. Use your finger to push the keypad from the front towards the circuit board. Remove the keypad from the phone.
  • Open the phone to expose the keypad.

  • Use your finger to push the keypad from the front towards the circuit board.

  • Remove the keypad from the phone.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Braden Burk

Membro da: 22/01/2012

1 Reputazione

10 Guide realizzate

Team

Cal Poly, Team 3-29, Amido Winter 2012 Membro di Cal Poly, Team 3-29, Amido Winter 2012

CPSU-AMIDO-W12S3G29

4 Membri

14 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 633