Introduzione

This guide will help you replace the keypad of the phone.

Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.
  • Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.

  • Poke out rubber covers using a spudger or pointy object, such as a thumb tack.

Aggiungi Commento

Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.
  • Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.

Aggiungi Commento

Use IPod opening tool to separate back housing.
  • Use IPod opening tool to separate back housing.

  • There are two tabs located on either side of the phone.

Aggiungi Commento

Separate the back housing from the phone.
  • Separate the back housing from the phone.

  • Be careful not to rip out the wire (highlighted in yellow) when separating the back housing.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Use a spudger to disconnect antenna wire.
  • Use a spudger to disconnect antenna wire.

Aggiungi Commento

Use the IPod opening tool to pop out the logic board.
  • Use the IPod opening tool to pop out the logic board.

Aggiungi Commento

Use the IPod opening tool to disconnect the main ribbon.
  • Use the IPod opening tool to disconnect the main ribbon.

Aggiungi Commento

Once the ribbon is detached, remove the logic board and replace if necessary.
  • Once the ribbon is detached, remove the logic board and replace if necessary.

Aggiungi Commento

The back of the keypad is shown here, next to the logic board (the logic board is turned over to expose the buttons).
  • The back of the keypad is shown here, next to the logic board (the logic board is turned over to expose the buttons).

Aggiungi Commento

Using a spudger, lift the keypad off of the tabs. Using a spudger, lift the keypad off of the tabs.
  • Using a spudger, lift the keypad off of the tabs.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Joshua Herrmann

Membro da: 16/04/2010

8 Reputazione

16 Guide realizzate

Team

Cal Poly, Team 6-14, Maness Spring 2010 Membro di Cal Poly, Team 6-14, Maness Spring 2010

CPSU-MANESS-S10S6G14

4 Membri

16 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 995