Introduzione

The front-facing camera may be causing problems due to either the ribbon cable not being connected properly or because the camera is broken. This guide should help you fix both problems.

Take your phone and place it screen down.
  • Take your phone and place it screen down.

Aggiungi Commento

Start by lifting the back panel using the gap located on the bottom-left side of the phone. Insert the plastic opening tool into the gap and move it along the edge of the phone until the rear case pops off. Insert the plastic opening tool into the gap and move it along the edge of the phone until the rear case pops off.
  • Start by lifting the back panel using the gap located on the bottom-left side of the phone.

  • Insert the plastic opening tool into the gap and move it along the edge of the phone until the rear case pops off.

Aggiungi Commento

Remove the battery from the phone. Remove the battery from the phone.
  • Remove the battery from the phone.

Aggiungi Commento

Remove the 13 screws found on the back of the phone. The screw circled in red is shorter than the other 12 screws. For an easier time when reassembling the phone, store it separately from the other screws.
  • Remove the 13 screws found on the back of the phone.

  • The screw circled in red is shorter than the other 12 screws. For an easier time when reassembling the phone, store it separately from the other screws.

Aggiungi Commento

Locate the same gap used in the earlier step Remove the bottom panel by gently lifting using your fingers
  • Locate the same gap used in the earlier step

  • Remove the bottom panel by gently lifting using your fingers

Aggiungi Commento

Remove the top panel by gently lifting with your finger
  • Remove the top panel by gently lifting with your finger

  • Do not pull up too forcefully, as there is a risk of the top panel breaking

Aggiungi Commento

Check to see that the ribbon cable is connected properly. If it was not, connect it and see if the front-facing camera now functions as intended. Otherwise, proceed
  • Check to see that the ribbon cable is connected properly. If it was not, connect it and see if the front-facing camera now functions as intended. Otherwise, proceed

  • Take the plastic opening tool and gently wedge it under where the ribbon cable is connected

  • Gently lift up to disconnect the ribbon cable

Aggiungi Commento

Repeat the same process for the other 3 ribbon cables connected to the motherboard Repeat the same process for the other 3 ribbon cables connected to the motherboard Repeat the same process for the other 3 ribbon cables connected to the motherboard
  • Repeat the same process for the other 3 ribbon cables connected to the motherboard

Aggiungi Commento

Remove the motherboard by lifting gently Take care not to damage the ribbon cables if the other components are functional. Damaging them may result in other components not working
  • Remove the motherboard by lifting gently

  • Take care not to damage the ribbon cables if the other components are functional. Damaging them may result in other components not working

Aggiungi Commento

Take the plastic opening tool and remove the front-facing camera by wedging it into the sides and under the ribbon cable and lifting up
  • Take the plastic opening tool and remove the front-facing camera by wedging it into the sides and under the ribbon cable and lifting up

  • The front-facing camera is kept in place with an adhesive, so it may take some time and effort to get it out. Depending on how much force you are using, it may also be launched across the room

Aggiungi Commento

Remove the old front-facing camera
  • Remove the old front-facing camera

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 11 persone hanno completato questa guida.

Naoto

Membro da: 16/10/2014

4.409 Reputazione

8 Guide realizzate

Team

UMass Dartmouth, Team 1-3, Duarte Fall 2014 Membro di UMass Dartmouth, Team 1-3, Duarte Fall 2014

UMASSD-DUARTE-F14S1G3

4 Membri

14 Guide realizzate

Naoto,

Thank you for the detailed guide it was very satisfying to repair this on my own.

please note: Image # 10 through me off for a few moments, until I realized it it was posted in mirror image mode.

For any one wanting to try this fix, I say “Go For It”

Also good to note: on my LG G3 . Once the back cover was removed, the inside back plate, comes apart in two sections the bottom 1/3 ( starting at the USB Charging port) is the first section that came apart.

Then the top section (starting beside the mid section of the battery housing) comes off easily.

Once completely removed, it was very easy to spot that the front facing camera ribbon connector just needed to be reset.

My phone feels brand new again :)

Again thank you

The Fix it Dude ,Fabian

The Fix Itdude - Replica

how can I fix the wifi 5g? I loss the 5g signal after reflow. please point out the position of the 5g IC and show the picture. thank you very much

wing lam - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 12

Ultimi 30 Giorni: 46

Tutti i Tempi: 7,566