Introduzione

The circuit board and full key board are attached and must be installed together as one unit. Do not try to separate them.

Place the phone so the screen side is facing down.
  • Place the phone so the screen side is facing down.

  • Locate the latch at the end of the phone, opposite of the camera.

Aggiungi Commento

Push/pull the latch away from the camera, causing the battery to pop out.
  • Push/pull the latch away from the camera, causing the battery to pop out.

Aggiungi Commento

Remove the battery.
  • Remove the battery.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Remove the 5 screw covers on the back of the phone using a Push Pin. Remove the 5 screw covers on the back of the phone using a Push Pin.
  • Remove the 5 screw covers on the back of the phone using a Push Pin.

Aggiungi Commento

With a Phillips #00 Screwdriver, remove the five 3.44 mm screws that were under the screw covers.
  • With a Phillips #00 Screwdriver, remove the five 3.44 mm screws that were under the screw covers.

  • Also with a Phillips #00 Screwdriver, remove the screw that was revealed once the battery was removed.

Aggiungi Commento

Open the phone. Open the phone.
  • Open the phone.

Aggiungi Commento

Starting at the card slot or charger port for greater ease, pry off the colored casing from the back of the phone using the Plastic Pry Tool (or a finger nail may work). Prying open the part just to the left of the right hinge can be difficult.
  • Starting at the card slot or charger port for greater ease, pry off the colored casing from the back of the phone using the Plastic Pry Tool (or a finger nail may work).

  • Prying open the part just to the left of the right hinge can be difficult.

  • Remove the back colored casing and set it to the side.

Aggiungi Commento

Gently pry and detach the connection located near the hinge with fingers. Gently pry and detach the connection located near the hinge with fingers.
  • Gently pry and detach the connection located near the hinge with fingers.

Aggiungi Commento

The circuit board and the key board will be attached, as shown in the second picture. Lift them both out from the rest of the phone.
  • The circuit board and the key board will be attached, as shown in the second picture.

  • Lift them both out from the rest of the phone.

  • Do not try to the detach key board pad from the circuit board. They are replaced as a unit.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team 15-15, Forte Spring 2012 Membro di Cal Poly, Team 15-15, Forte Spring 2012

CPSU-FORTE-S12S15G15

5 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,075