Salta al contenuto principale

Kid Galaxy Morphibians Explorer On/Off Switch Replacement

Cosa ti serve

  1. Kid Galaxy Morphibians Explorer On/Off Switch  Replacement, Remove the Top Cover: passo 1, immagine 1 di 1
    • First, completely loosen the 9.6 mm Phillips #2 screw on top. There is a plastic washer that holds the screw to the top cover, so it will not need to be taken out.

  2. Kid Galaxy Morphibians Explorer On/Off Switch  Replacement: passo 2, immagine 1 di 1
    • After the screw has been loosened, lift the cover off.

  3. Kid Galaxy Morphibians Explorer On/Off Switch  Replacement: passo 3, immagine 1 di 1
    • Completely loosen the 9.6 mm Phillips #2 screw from the battery cover. Once again, there is a plastic washer to hold the screw to the cover.

  4. Kid Galaxy Morphibians Explorer On/Off Switch  Replacement: passo 4, immagine 1 di 1
    • After the screw is loosened, lift the battery cover off the top cover to gain access to the batteries.

    • Turn the RC car over to reach the six screws on the bottom.

  5. Kid Galaxy Morphibians Explorer On/Off Switch  Replacement: passo 5, immagine 1 di 1
    • Remove the six 11.6 mm Phillips #2 screws on the bottom cover.

    • (Wheels are removed in this picture to clearly show screw location. They do not need to be removed for this step)

  6. Kid Galaxy Morphibians Explorer On/Off Switch  Replacement: passo 6, immagine 1 di 1
    • Lift the top Cover off the car.

  7. Kid Galaxy Morphibians Explorer On/Off Switch  Replacement, On/Off Switch: passo 7, immagine 1 di 1
    • On the top of the inside cover you will see the back side of the on/off switch. Remove the two 7.2 mm Philips #00 head screws holding the switch in place.

  8. Kid Galaxy Morphibians Explorer On/Off Switch  Replacement: passo 8, immagine 1 di 1
    • Gently pull the on/off switch off the inside cover.

    • Remove the positive (red wire) and negative (black wire) terminals from the bottom of the batter cover. Snip the wires using wire cutters.

    • Remove to freed on/off switch from the inside cover.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

USF Tampa, Team 1-2, Hickman Fall 2014 Membro di USF Tampa, Team 1-2, Hickman Fall 2014

USFT-HICKMAN-F14S1G2

3 Membri

7 Guide realizzate

Un commento

In the last step, Step 8 second bullet. Could add a image of actually showing how its done.

Dishant Patel - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 458