Introduzione

This guide will assist with replacing a non-functioning projector lamp, which is responsible for providing the light necessary for projection.

Parti

Nessuna parte richiesta.

Place the projector on its back with the control buttons facing down. Remove the black  7mm screw on the external case with a Phillips 2 screwdriver.
  • Place the projector on its back with the control buttons facing down.

  • Remove the black 7mm screw on the external case with a Phillips 2 screwdriver.

Aggiungi Commento

Use the plastic flat-head to remove the lamp lid.
  • Use the plastic flat-head to remove the lamp lid.

Aggiungi Commento

Remove the 7mm screw near the bottom center with a Philips 2 screwdriver head. Loosen but do not remove the 7mm screw near the upper right corner with the Phillips 2 screwdriver head.
  • Remove the 7mm screw near the bottom center with a Philips 2 screwdriver head.

  • Loosen but do not remove the 7mm screw near the upper right corner with the Phillips 2 screwdriver head.

Aggiungi Commento

Grab the silver handle. Unhook the handle so it can move freely. Pull the handle straight up until the lamp is completely removed from projector.
  • Grab the silver handle.

  • Unhook the handle so it can move freely.

  • Pull the handle straight up until the lamp is completely removed from projector.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Jorge L Navarro

Membro da: 22/01/2014

533 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 13-17, Regan Winter 2014 Membro di Cal Poly, Team 13-17, Regan Winter 2014

CPSU-REGAN-W14S13G17

6 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 29

Tutti i Tempi: 1,807