Introduzione

The filter on the Dyson DC14 vacuum needs to be cleaned every six months in order to maintain its peak operating condition.

Strumenti

Nessun attrezzo richiesto.

Parti

The filter is located in the canister of your vacuum.
  • The filter is located in the canister of your vacuum.

Aggiungi Commento

Open the canister filter compartment.  Push the clip upwards, and open the canister top away from you. Remove the yellow filter housing. Remove the yellow filter housing.
  • Open the canister filter compartment. Push the clip upwards, and open the canister top away from you.

  • Remove the yellow filter housing.

Aggiungi Commento

Remove the blue sponge-filter from the yellow filter housing.
  • Remove the blue sponge-filter from the yellow filter housing.

    • The filter and housing must both be completely dry before reinstalling. Do not use your vacuum without filters installed.

  • Clean the blue sponge-filter in cold water until the water runs clear.

Aggiungi Commento

Conclusione

Once the filter is cleaned, set the blue filter sponge and the yellow filter housing aside for at least 24 hours to dry. Do not use your vacuum without a filter, or when the filter is still wet. To reassemble, follow the steps in reverse order.

Altre 8 persone hanno completato questa guida.

Donald Percivalle

Membro da: 03/10/2012

1.162 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 3-22, Amido Fall 2012 Membro di Cal Poly, Team 3-22, Amido Fall 2012

CPSU-AMIDO-F12S3G22

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 34

Ultimi 7 Giorni: 143

Ultimi 30 Giorni: 629

Tutti i Tempi: 18,907