Introduzione

The bottom half of the phone will need to be disassembled, see "replacing logic board" for instructions to remove logic board.

Parti

Nessuna parte richiesta.

Remove the back panel by pressing up on switch, located at the top on the back of the phone.
  • Remove the back panel by pressing up on switch, located at the top on the back of the phone.

  • You may want to use a plastic opening tool to help pry the back panel off.

Aggiungi Commento

Unscrew the four 4.5mm screws located on the back plate.
  • Unscrew the four 4.5mm screws located on the back plate.

Aggiungi Commento

Remove the rubber screw cover using your fingernail.
  • Remove the rubber screw cover using your fingernail.

Aggiungi Commento

Unscrew the 4.5mm screw located underneath the rubber cover.
  • Unscrew the 4.5mm screw located underneath the rubber cover.

Aggiungi Commento

Wedge the end of a plastic opening tool into the crack between the back panel and the phone.
  • Wedge the end of a plastic opening tool into the crack between the back panel and the phone.

  • The panel should come off without much effort.

Aggiungi Commento

With the back panel removed, the motherboard should be fully exposed.
  • With the back panel removed, the motherboard should be fully exposed.

Aggiungi Commento

Remove the camera and volume buttons and place them in a safe spot until reassembly. Remove the camera and volume buttons and place them in a safe spot until reassembly.
  • Remove the camera and volume buttons and place them in a safe spot until reassembly.

Aggiungi Commento

Using a plastic opening tool, unplug the ribbon cable connecting the front LCDs to the motherboard. Using a plastic opening tool, unplug the ribbon cable connecting the front LCDs to the motherboard.
  • Using a plastic opening tool, unplug the ribbon cable connecting the front LCDs to the motherboard.

Aggiungi Commento

Detach the motherboard by grabbing the edges of it and lifting it straight out of the phone. Detach the motherboard by grabbing the edges of it and lifting it straight out of the phone.
  • Detach the motherboard by grabbing the edges of it and lifting it straight out of the phone.

Aggiungi Commento

After removing motherboard, the phone will look like this.
  • After removing motherboard, the phone will look like this.

Aggiungi Commento

Grab the corner of the rubber key pad and lift out slowly.
  • Grab the corner of the rubber key pad and lift out slowly.

Aggiungi Commento

By using a small standard screwdriver and a fine, thin, soft cloth you can clean in between the keypad to remove dirt and debris. By using a small standard screwdriver and a fine, thin, soft cloth you can clean in between the keypad to remove dirt and debris.
  • By using a small standard screwdriver and a fine, thin, soft cloth you can clean in between the keypad to remove dirt and debris.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Joe Cavaletto

Membro da: 30/01/2011

101 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 11-23, Maness Winter 2011 Membro di Cal Poly, Team 11-23, Maness Winter 2011

CPSU-MANESS-W11S11G23

4 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 836