Parti

Nessuna parte richiesta.

Before starting, be sure to remove the battery from the camera. See Removing the Olympus Stylus 760 Battery Guide for details.

Aggiungi Commento

Remove the screw located on the right side of the camera

  • Remove the screw located on the right side of the camera


Aggiungi Commento

Remove the two screws from the left side of the camera
  • Remove the two screws from the left side of the camera

Aggiungi Commento

Use a small prying device to delicately separate the front casing from the back.
New line.
  • Use a small prying device to delicately separate the front casing from the back.
New line.

    • When separating the 2 cases be cautious of the silver band and buttons that located in the middle of the camera. They will come loose.

Aggiungi Commento

Remove the 2 screws on the right side of the camera. Remove the 2 screwson the left side of the camera CAUTION! Circuit ribbon is attached at the top left of the camera be careful when separating the front and back of the camera after removing the 4 screws.
  • Remove the 2 screws on the right side of the camera.

  • Remove the 2 screwson the left side of the camera

  • CAUTION! Circuit ribbon is attached at the top left of the camera be careful when separating the front and back of the camera after removing the 4 screws.

Aggiungi Commento

Carefully flip up the clip attaching the ribbon from the rear to the front and pull it out

  • Carefully flip up the clip attaching the ribbon from the rear to the front and pull it out


Aggiungi Commento

Carefully separate the front and back of the camera

  • Carefully separate the front and back of the camera


Aggiungi Commento

You should be left with 4 large pieces, the outer case, inner lens piece, outer silver band and back case containing the LCD display. 

  • You should be left with 4 large pieces, the outer case, inner lens piece, outer silver band and back case containing the LCD display. 


Aggiungi Commento

Using a size 0 Phillips head, remove 3 screws holding the ribbon cable that covers the back of the lens.
  • Using a size 0 Phillips head, remove 3 screws holding the ribbon cable that covers the back of the lens.

  • CAUTION: small loose pieces under the back lens cover

Aggiungi Commento

Using tweezers remove tiny square lens cases.  There are 4 small pieces.
  • Using tweezers remove tiny square lens cases. There are 4 small pieces.

  • The pieces are relatively small, so becareful that they do not fall inside of the lens.

Aggiungi Commento

Remove the larger black rubber frame. Clean with condensed air.
  • Remove the larger black rubber frame. Clean with condensed air.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Derek Guzman

Membro da: 10/02/2012

17 Reputazione

1 Guida realizzata

Team

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 19

Tutti i Tempi: 1,138