Introduzione

This guide will walk you through taking apart the mouse and repairing the left and right mouse buttons.

Parti

Nessuna parte richiesta.

Unplug the USB cord to disconnect the mouse from power.
  • Unplug the USB cord to disconnect the mouse from power.

  • On the bottom side of the mouse, unscrew the single screw located above the rotating ball.

The screw on this mouse is a #2 phillips.

Brandon - Replica

Take off the top of the mouse and remove any debris located inside of the highlighted areas.
  • Take off the top of the mouse and remove any debris located inside of the highlighted areas.

  • Use a microfiber cloth first then, damp towel for areas that are more difficult to clean.

To take off the top part, you will want to lift the cover up just by a centimeter or two, and then slide it towards the back of the mouse while pulling up.

Brandon - Replica

The ball may be stuck or dirty and isn't relaying correctly. To remove or clean the ball, twist the ball cover according to the arrows (counter-clockwise).
  • The ball may be stuck or dirty and isn't relaying correctly. To remove or clean the ball, twist the ball cover according to the arrows (counter-clockwise).

Aggiungi Commento

These are the vertical and horizontal ball sensors. These can become dirty from excessive use. Clean these with proper materials to insure cooperation.
  • These are the vertical and horizontal ball sensors. These can become dirty from excessive use. Clean these with proper materials to insure cooperation.

Aggiungi Commento

Insert the USB Cable back into your computer.
  • Insert the USB Cable back into your computer.

Aggiungi Commento

Examine the cord for frays or any exposed wires that may cause a bad connection.
  • Examine the cord for frays or any exposed wires that may cause a bad connection.

Aggiungi Commento

Examine wheel for debris. The wheel can get dirty frequently which affects performance and may cause issues.
  • Examine wheel for debris. The wheel can get dirty frequently which affects performance and may cause issues.

Aggiungi Commento

This highlights that the sensor may be dirty or broken.
  • This highlights that the sensor may be dirty or broken.

Aggiungi Commento

The wheel button sensor may be stuck or not working. Pull the wheel out to expose it and clean it.
  • The wheel button sensor may be stuck or not working. Pull the wheel out to expose it and clean it.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Team

Montana Tech, Team 1-4, Shirk Fall 2014 Membro di Montana Tech, Team 1-4, Shirk Fall 2014

MTUM-SHIRK-F14S1G4

3 Membri

1 Guida realizzata

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 8

Tutti i Tempi: 454