Introduzione

The only tool needed is a #00 Phillips Screw driver.

Parti

Nessuna parte richiesta.

Remove the six 4.1 mm Phillips screws from the back plate using the #00 Phillips Scewdriver.
  • Remove the six 4.1 mm Phillips screws from the back plate using the #00 Phillips Scewdriver.

Aggiungi Commento

Remove the black plate from the PDA.
  • Remove the black plate from the PDA.

Aggiungi Commento

Remove four 2.6 mm Philips screws that are on the sides of the frame. Remove the remaining 3.9 mm Philips screw holding together the stylus holster and the frame.
  • Remove four 2.6 mm Philips screws that are on the sides of the frame.

  • Remove the remaining 3.9 mm Philips screw holding together the stylus holster and the frame.

Aggiungi Commento

Remove the four 2.6 mm Philips screws on the top and bottom of the frame. Remove the four 2.6 mm Philips screws on the top and bottom of the frame.
  • Remove the four 2.6 mm Philips screws on the top and bottom of the frame.

Aggiungi Commento

Remove the white frame from the PDA.
  • Remove the white frame from the PDA.

  • The frame may get stuck on the corners so be very gentle when working the corners off.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Nick Lazarakis

Membro da: 23/01/2011

331 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 11-28, Maness Winter 2011 Membro di Cal Poly, Team 11-28, Maness Winter 2011

CPSU-MANESS-W11S11G28

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 909