Introduzione

If your Fortress' camera is malfunctioning and you've ruled out any software problems, you may want to install a new Camera.

In this guide, you'll learn how to install the HTC Fortress camera. This guide requires a moderate amount of dismantling of your phone with tools from the iFixit tool kit.

Remove the back cover of the device by sliding it upward. You may need to remove the phone stylus first.
  • Remove the back cover of the device by sliding it upward.

  • You may need to remove the phone stylus first.

Aggiungi Commento

Remove the battery by pulling it away from the back of the phone. Remove the battery by pulling it away from the back of the phone.
  • Remove the battery by pulling it away from the back of the phone.

Aggiungi Commento

Remove the top 2 screws on the back of the phone with the T4 Screwdriver. Remove the top 2 screws on the back of the phone with the T4 Screwdriver.
  • Remove the top 2 screws on the back of the phone with the T4 Screwdriver.

Aggiungi Commento

Remove the camera panel by hand (black cover above the battery slot). Be careful; there is a cable attached underneath the case. It does detach, just pull on it carefully. During reassembly, put the cable back in by holding the black piece slightly above its slot and using the spudger to gently press the end of the cable back into its fitting. Then, insert the black piece so it is flush with the black panel again.
  • Remove the camera panel by hand (black cover above the battery slot).

  • Be careful; there is a cable attached underneath the case. It does detach, just pull on it carefully.

  • During reassembly, put the cable back in by holding the black piece slightly above its slot and using the spudger to gently press the end of the cable back into its fitting. Then, insert the black piece so it is flush with the black panel again.

Aggiungi Commento

Work the metal camera casing off by slowly prying up the sides using the spudger. Work the metal camera casing off by slowly prying up the sides using the spudger. Work the metal camera casing off by slowly prying up the sides using the spudger.
  • Work the metal camera casing off by slowly prying up the sides using the spudger.

Aggiungi Commento

Use the tweezers to pull the camera straight out of the phone. Use the tweezers to pull the camera straight out of the phone.
  • Use the tweezers to pull the camera straight out of the phone.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Lucas David

Membro da: 19/04/2013

523 Reputazione

9 Guide realizzate

Team

Cal Poly, Team 4-13, Maness Spring 2013 Membro di Cal Poly, Team 4-13, Maness Spring 2013

CPSU-MANESS-S13S4G13

4 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 275