Salta al contenuto principale

HP Photosmart D110a Power Button Replacement

Cosa ti serve

  1. HP Photosmart D110a Power Button Replacement, Power Button: passo 1, immagine 1 di 1
    • Open the printer's mouth by pulling the two mouth pieces down.

    • Lift the flap covering the scanner. When you are finished, the printer should appear as shown.

  2. HP Photosmart D110a Power Button Replacement: passo 2, immagine 1 di 1
    • Remove the flap for the scanner by pulling lightly on the clip that attaches it to the printer.

    • The clip may be damaged by applying too much force.

  3. HP Photosmart D110a Power Button Replacement: passo 3, immagine 1 di 3 HP Photosmart D110a Power Button Replacement: passo 3, immagine 2 di 3 HP Photosmart D110a Power Button Replacement: passo 3, immagine 3 di 3
    • Remove the three screws from the top of the printer using a T9 screwdriver as shown.

    • The screws are located in the far-left, far-right, and near-right corners of the printer, with respect to the front view.

  4. HP Photosmart D110a Power Button Replacement: passo 4, immagine 1 di 1
    • Reach into the mouth of the printer and press the clip behind the power button to release the power button face.

  5. HP Photosmart D110a Power Button Replacement: passo 5, immagine 1 di 1
    • A picture of the removed power button is provided to show the location of the clip that needs to be pressed.

    • After pressing the clip, pull out the face of the power button by sliding it from the right to the left side.

  6. HP Photosmart D110a Power Button Replacement: passo 6, immagine 1 di 3 HP Photosmart D110a Power Button Replacement: passo 6, immagine 2 di 3 HP Photosmart D110a Power Button Replacement: passo 6, immagine 3 di 3
    • The power button face has a plastic holder that attaches the power button and the wireless button to the face plate using two slots.

    • Loosen the plastic holder by pulling the slots on the face plate away from the plastic holder.

    • Remove the plastic holder from the face plate after the slots are loosened.

  7. HP Photosmart D110a Power Button Replacement: passo 7, immagine 1 di 3 HP Photosmart D110a Power Button Replacement: passo 7, immagine 2 di 3 HP Photosmart D110a Power Button Replacement: passo 7, immagine 3 di 3
    • The plastic holder secures the power button by two slots.

    • Using a spudger, push the holders inward to detach the button from the plastic holder.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Tim Wise

Membro da: 04/01/11

173 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 10-38, Forte Spring 2011 Membro di Cal Poly, Team 10-38, Forte Spring 2011

CPSU-FORTE-S11S10G38

5 Membri

10 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 3,530