Parti

Nessuna parte richiesta.

Remove one 9mm T10 Torx screw from the back of the printer lid.
  • Remove one 9mm T10 Torx screw from the back of the printer lid.

Aggiungi Commento

Press outward on the plastic tab holding the back panel in place. Press outward on the plastic tab holding the back panel in place.
  • Press outward on the plastic tab holding the back panel in place.

Aggiungi Commento

Pull the back panel towards you and lift it away from the rest of the printer cover. Some ribbon cables may still be inserted through the back panel. Be careful not to damage these and they should slide out easily.
  • Pull the back panel towards you and lift it away from the rest of the printer cover.

  • Some ribbon cables may still be inserted through the back panel. Be careful not to damage these and they should slide out easily.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Tim

Membro da: 15/01/2013

131 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 18-35, Regan Winter 2013 Membro di Cal Poly, Team 18-35, Regan Winter 2013

CPSU-REGAN-W13S18G35

5 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 26

Tutti i Tempi: 1,530