Gateway SA1 Hard Drive Replacement - Guida di riparazione iFixit

Introduzione

Upgrading the hard drive capacity by replacing the original drive.

Cosa ti serve

Passo 1 Battery

Gateway SA1 Hard Drive Replacement, Battery: passo 1, immagine 1 di 1

Move the latch to the right of the battery to unlock.

Passo 2

Gateway SA1 Hard Drive Replacement: passo 2, immagine 1 di 1

Slide the latch on the left directly below the battery to unlock and pull out the battery as shown.
The latch must be held in position to remove the battery.

Passo 3 Hard Drive

Gateway SA1 Hard Drive Replacement, Hard Drive: passo 3, immagine 1 di 1

Before you begin, it's recommended that you back up all your computer's information on the original hard drive. Also, verify the laptop is off and all cables are disconnected.
Turn the laptop over so the bottom is facing up.

Passo 4

Gateway SA1 Hard Drive Replacement: passo 4, immagine 1 di 2

Gateway SA1 Hard Drive Replacement: passo 4, immagine 2 di 2

Loosen the three Philips cover screws that secure the hard drive.
These screws cannot be fully removed from the hard drive cover.
Use the spudger to lift and to remove the hard drive cover.

Passo 5

Gateway SA1 Hard Drive Replacement: passo 5, immagine 1 di 2

Gateway SA1 Hard Drive Replacement: passo 5, immagine 2 di 2

Slide the original hard drive to the left and lift it to remove.
Insert the new hard drive.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 5 persone hanno completato questa guida.

Autore

con 7 altri collaboratori

Diego Carteno

Membro da: 04/15/10

258 Reputazione

7 Guide realizzate

+11 altri distintivi

Team

Cal Poly, Team 24-20, Regan Spring 2010 Membro di Cal Poly, Team 24-20, Regan Spring 2010

CPSU-REGAN-S10S24G20

4 Membri

14 Guide realizzate

0 Commenti

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 9

Tutti i Tempi: 13,886