Introduzione

You are going to remove the back cover, remove wires and screws from the Wireless Card, and take it out. You can then either reassemble it or replace it.

Parti

Nessuna parte richiesta.

Place the laptop so the back cover is facing up.
  • Place the laptop so the back cover is facing up.

Aggiungi Commento

Remove the 8 screws from the back cover using the Phillips #00 screwdriver.
  • Remove the 8 screws from the back cover using the Phillips #00 screwdriver.

Aggiungi Commento

Lift off the cover.
  • Lift off the cover.

Aggiungi Commento

The wireless card is located to the right of the hard drive and below the RAM.
  • The wireless card is located to the right of the hard drive and below the RAM.

Aggiungi Commento

There are black and grey wires with gold heads attached to the top of the wireless card.
  • There are black and grey wires with gold heads attached to the top of the wireless card.

  • To remove these wires, turn the gold heads counterclockwise and pull up.

  • You will hear a snap when the heads come off.

  • It does not matter which wire you remove first, but do so one at a time.

Aggiungi Commento

Remove the two screws next to the wires with a Phillips #00 screw driver.
  • Remove the two screws next to the wires with a Phillips #00 screw driver.

Aggiungi Commento

The card will pop up 20 degrees and is loose enough to remove with your hand.
  • The card will pop up 20 degrees and is loose enough to remove with your hand.

  • Carefully pull the card out to the left horizontally.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Toni Pipes

Membro da: 05/10/2010

297 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 21-31, Regan Fall 2010 Membro di Cal Poly, Team 21-31, Regan Fall 2010

CPSU-REGAN-F10S21G31

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 3

Tutti i Tempi: 3,841