Place the laptop upside down on a table.
  • Place the laptop upside down on a table.

Place the laptop upside down on a table. (to the point...)

Bruce - Replica

Why is it asking me for a second comment?

Bruce - Replica

Locate the battery (the grey block). Find the two tabs on one end of the battery near the side of the laptop.
  • Locate the battery (the grey block). Find the two tabs on one end of the battery near the side of the laptop.

  • Using your fingers, press both tabs down at once until they are fully depressed.

Aggiungi Commento

While holding the tabs down, slowly pivot the battery up.
  • While holding the tabs down, slowly pivot the battery up.

  • The battery is now free and safe to pull out.

Aggiungi Commento

Unscrew three 2.4mm and one 5.7mm screws using a Phillips # 0. Unscrew three 1.9mm screws in the battery compartment still using a Phillips # 0
  • Unscrew three 2.4mm and one 5.7mm screws using a Phillips # 0.

  • Unscrew three 1.9mm screws in the battery compartment still using a Phillips # 0

Aggiungi Commento

Mind the wire connections on the bottom right side of the monitor. They are still connected between the monitor and computer. Raise the monitor as you normally would until it pops out by itself.  Rotate the left side up and to the right to unhook hinges that may catch on the computer. Lay the monitor flat next to the computer.
  • Mind the wire connections on the bottom right side of the monitor. They are still connected between the monitor and computer.

  • Raise the monitor as you normally would until it pops out by itself. Rotate the left side up and to the right to unhook hinges that may catch on the computer.

  • Lay the monitor flat next to the computer.

Aggiungi Commento

Using a smaller spudger (like a PX3688), pivot the sound case out above the "F2" and "Insert" buttons. Lift the case out and set it aside.
  • Using a smaller spudger (like a PX3688), pivot the sound case out above the "F2" and "Insert" buttons.

  • Lift the case out and set it aside.

  • For the proceeding steps, put on your anti-static wrist strap and attach the metal clip to something metal and grounded in order to protect the delicate circuitry inside the computer.

Aggiungi Commento

Using the same spudger, pry the top of the keyboard up above the "F2" key. Turn the computer so that the bottom is facing you. The keyboard is connected to a black plastic strip, slowly pull the keyboard and place it to the side.
  • Using the same spudger, pry the top of the keyboard up above the "F2" key.

  • Turn the computer so that the bottom is facing you.

  • The keyboard is connected to a black plastic strip, slowly pull the keyboard and place it to the side.

Aggiungi Commento

Disconnect the keyboard by gently pulling on the hard plastic square straight up from  the white connector. Disconnect the keyboard by gently pulling on the hard plastic square straight up from  the white connector.
  • Disconnect the keyboard by gently pulling on the hard plastic square straight up from the white connector.

Aggiungi Commento

Peel the white tape from the wires connected to the monitor, but do not completely remove it. Unplug the white and black wires with your fingers. Unplug the white and black wires with your fingers.
  • Peel the white tape from the wires connected to the monitor, but do not completely remove it.

  • Unplug the white and black wires with your fingers.

Aggiungi Commento

Unplug the white chip connected to the thicker wire with two smaller spudgers (like a PX3688) by wiggling it back and forth until it pops out. Unplug the white chip connected to the thicker wire with two smaller spudgers (like a PX3688) by wiggling it back and forth until it pops out. Unplug the white chip connected to the thicker wire with two smaller spudgers (like a PX3688) by wiggling it back and forth until it pops out.
  • Unplug the white chip connected to the thicker wire with two smaller spudgers (like a PX3688) by wiggling it back and forth until it pops out.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Nicholas Ross

Membro da: 20/01/2012

134 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 10-31, Amido Winter 2012 Membro di Cal Poly, Team 10-31, Amido Winter 2012

CPSU-AMIDO-W12S10G31

5 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 4

Tutti i Tempi: 2,153