Introduzione

The Selector is an important part of the camera because it controls the LCD screen. To replace it, follow the below steps.

Strumenti

Nessun attrezzo richiesto.

Parti

Nessuna parte richiesta.

Turn the camera upside down so you can access the battery chamber.
  • Turn the camera upside down so you can access the battery chamber.

  • Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

Aggiungi Commento

Push the battery chamber latch in the direction of the front of the camera.  Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.
  • Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.

Aggiungi Commento

With the battery chamber open, remove the old batteries.
  • With the battery chamber open, remove the old batteries.

  • When replacing the batteries, remember that the battery orientation is shown by the + and - marks. Each mark indicates which side of the battery faces up in the chamber.

Aggiungi Commento

Remove the 4mm JIS #00 screws from the sides and bottom of the camera. Remove the 4mm JIS #00 screws from the sides and bottom of the camera. Remove the 4mm JIS #00 screws from the sides and bottom of the camera.
  • Remove the 4mm JIS #00 screws from the sides and bottom of the camera.

Aggiungi Commento

Carefully pry away the rear housing cover with the plastic opening tool. Carefully pry away the rear housing cover with the plastic opening tool. Carefully pry away the rear housing cover with the plastic opening tool.
  • Carefully pry away the rear housing cover with the plastic opening tool.

Aggiungi Commento

Remove the rear housing cover by carefully pulling it away from the camera.
  • Remove the rear housing cover by carefully pulling it away from the camera.

Aggiungi Commento

To Replace the Selection button, carefully pull the button until the button has been fully detached.
  • To Replace the Selection button, carefully pull the button until the button has been fully detached.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Ugent Dailey

Membro da: 20/01/2015

119 Reputazione

1 Guida realizzata

Team

USF Tampa, Team 7-1, Remmell Winter 2015 Membro di USF Tampa, Team 7-1, Remmell Winter 2015

USFT-REMMELL-W15S7G1

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 8

Tutti i Tempi: 443