Introduzione

Use this guide to replace the battery door.

Parti

Nessuna parte richiesta.

Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.
  • Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.

Aggiungi Commento

Locate the battery door.
  • Locate the battery door.

Aggiungi Commento

Locate the latch on the battery door.
  • Locate the latch on the battery door.

  • Use your finger pry to it open where it says "BATT."

Aggiungi Commento

Remove the battery from the camera by pulling the battery door outward.
  • Remove the battery from the camera by pulling the battery door outward.

Aggiungi Commento

Locate and remove three black 3.80mm screws on the back of the black casing with the Phillips #00 screwdriver.
  • Locate and remove three black 3.80mm screws on the back of the black casing with the Phillips #00 screwdriver.

Aggiungi Commento

Squeeze the camera placing a thumb on the tab marked CE.
  • Squeeze the camera placing a thumb on the tab marked CE.

  • Pull the back half of the camera firmly away from the camera body.

Aggiungi Commento

Locate and remove the 3.80mm screw that holds the plastic strip to the camera body with a Phillips #00 screwdriver. The plastic strip will now come off the camera body.
  • Locate and remove the 3.80mm screw that holds the plastic strip to the camera body with a Phillips #00 screwdriver.

  • The plastic strip will now come off the camera body.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Eric Nicolai

Membro da: 10/01/2011

679 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 13-5, Forte Winter 2011 Membro di Cal Poly, Team 13-5, Forte Winter 2011

CPSU-FORTE-W11S13G5

5 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,639