Parti

Nessuna parte richiesta.

Flip device upside down and remove the 4 foam pads at each corner.
  • Flip device upside down and remove the 4 foam pads at each corner.

Aggiungi Commento

  • Remove the 4 screws using a Philips Screwdriver.

Aggiungi Commento

  • Gently lift the case off of the body and set down in a safe place.

Aggiungi Commento

Unscrew the 5 screws in the base circuit board.
  • Unscrew the 5 screws in the base circuit board.

Aggiungi Commento

Use the tweezers to slightly lift the circuit board, allowing the cylindrical alarm piece to slide out.
  • Use the tweezers to slightly lift the circuit board, allowing the cylindrical alarm piece to slide out.

Aggiungi Commento

Check if the wires are secured.
  • Check if the wires are secured.

Aggiungi Commento

  • If they are not attached, you may re-solder it together. If they are attached, that means it is a faulty alarm and should replace it.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 12

Tutti i Tempi: 566