Introduzione

The scanner motor powers the physical movement of the scanning mechanism. This mechanism moves across an entire document, copying its contents, so that the printer can scan, fax, and/or print a copy of the original document. This motor may stop working due to a broken fuse or faulty connection and ultimately may need to be replaced.

Parti

Nessuna parte richiesta.

Check that the printer is unplugged to prevent shock.
  • Check that the printer is unplugged to prevent shock.

  • Turn the printer so the front buttons are facing away from you.

Aggiungi Commento

Locate the 3mm Phillips #0 screw in the top left corner of the printer.
  • Locate the 3mm Phillips #0 screw in the top left corner of the printer.

  • Remove the screw using a Phillips head screwdriver.

  • Store the screw in a safe place where you can access them later.

Aggiungi Commento

Flip the top of the printer up so that you can see the inside of the printer.
  • Flip the top of the printer up so that you can see the inside of the printer.

  • There is a white ribbon cable in the right top corner of the printer.

  • Make sure that the white ribbon does not come detached from the right side of the printer.

Aggiungi Commento

Lay the scanner face up so you can access the under side, and place something, such as a piece of Styrofoam, underneath of it so that the white tape does not become detached.
  • Lay the scanner face up so you can access the under side, and place something, such as a piece of Styrofoam, underneath of it so that the white tape does not become detached.

  • Locate the four 3mm Phillips #2 screws along the edge, and remove all of them.

  • Store the screws in a safe place where you can access them later.

Aggiungi Commento

Locate the seam on between outer shell of the printer and the inside of the printer. Starting from the top of the printer, use the plastic opening tool to slowly pry the scanner apart along the seam.
  • Locate the seam on between outer shell of the printer and the inside of the printer.

  • Starting from the top of the printer, use the plastic opening tool to slowly pry the scanner apart along the seam.

Aggiungi Commento

Detach the bottom of the scanner. Flip the bottom of the scanner over so that it rests on top of the printer.
  • Detach the bottom of the scanner.

  • Flip the bottom of the scanner over so that it rests on top of the printer.

  • This gives you access to the motor.

Aggiungi Commento

Gently lift the scanner bar in order to remove it from the scanner.
  • Gently lift the scanner bar in order to remove it from the scanner.

  • Detach the white ribbon cable from the scanner bar.

Aggiungi Commento

Remove the two 3mm Phillips #2 screws on the underside of the scanner bar attached to the silver motor.
  • Remove the two 3mm Phillips #2 screws on the underside of the scanner bar attached to the silver motor.

  • Remove the motor from the scanner bar by gently pulling the motor upwards.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Kimberly Pugel

Membro da: 07/04/2014

374 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 6-1, Forte Spring 2014 Membro di Cal Poly, Team 6-1, Forte Spring 2014

CPSU-FORTE-S14S6G1

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 471