Aggiusta la tua roba Comunità Store

Epson Powerlite S5 Projection Lamp Replacement

Introduzione

The Epson Powerlite S5 projection lamp will need replacement after about 3000 hours of use. If you get an orange blinking light or "replace lamp" message, this guide will help in bringing your projector back to life.

Cosa ti serve

  1. Epson Powerlite S5 Projection Lamp Replacement, Projection Lamp: passo 1, immagine 1 di 2 Epson Powerlite S5 Projection Lamp Replacement, Projection Lamp: passo 1, immagine 2 di 2

    • Make sure the power is off before beginning.

    • Unplug the projector's power cord from the wall.

    • Allow the projection lamp to cool completely before replacing.

    Traduci

  2. Epson Powerlite S5 Projection Lamp Replacement: passo 2, immagine 1 di 2 Epson Powerlite S5 Projection Lamp Replacement: passo 2, immagine 2 di 2

    • Using a Phillip's head screwdriver, remove the screw from the back.

    Traduci

  4. Epson Powerlite S5 Projection Lamp Replacement: passo 3, immagine 1 di 3 Epson Powerlite S5 Projection Lamp Replacement: passo 3, immagine 2 di 3 Epson Powerlite S5 Projection Lamp Replacement: passo 3, immagine 3 di 3

    • Slide the cover back.

    • Lift cover to remove.

    Traduci

  5. Epson Powerlite S5 Projection Lamp Replacement: passo 4, immagine 1 di 3 Epson Powerlite S5 Projection Lamp Replacement: passo 4, immagine 2 di 3 Epson Powerlite S5 Projection Lamp Replacement: passo 4, immagine 3 di 3

    • Locate the two screws on either side of the projection lamp.

    • Using a Phillip's head screwdriver, loosen the two screws.

    • The screws only loosen. You don't have to worry about them falling out.

    Traduci

  6. Epson Powerlite S5 Projection Lamp Replacement: passo 5, immagine 1 di 3 Epson Powerlite S5 Projection Lamp Replacement: passo 5, immagine 2 di 3 Epson Powerlite S5 Projection Lamp Replacement: passo 5, immagine 3 di 3

    • Grip the two plastic bars on the top of the old projection lamp.

    • Remove the projection lamp by pulling straight up.

    • If there is any lamp breakage, handle the shards carefully to avoid injury.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 2 altri collaboratori

Greg Brown

Membro da: 10/06/16

121 Reputazione

1 Guida realizzata

Distintivi: 3

Team

University of Memphis, Team 4-2, Baddour Fall 2016 Membro di University of Memphis, Team 4-2, Baddour Fall 2016

UM-BADDOUR-F16S4G2

3 Membri

1 Guida realizzata

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 7

Tutti i Tempi: 1,218